Module bent or glass warped OK Kristopher is the glass warped or is the frame bent, looking at the pic, there is cardboard spacing each module so there is a gap. If the binders are in the middle then that will bend one or more modules on each side, now to bend them all the way through that center binder would have to be very tight or strapped on a truck in shipping. If it is the glass then its manufacturing and poor QC, my money if it is the frames is shipping and or packaging, but that's just me. Jerry
On Sat, Nov 16, 2019, 7:12 AM Kristopher Schmid <sol...@legacysolar.com> wrote: > So, I opened up a pallet of Jinko 400 watt half cell modules yesterday and > noticed that every module was convex to the glass side. The center was 1/4 > inch higher than the corners. Has anyone else seen this? Should I be > concerned? Manufacturing issue? Intentional? > > Thanks, > Kris > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > www.members.re-wrenches.org > >
_______________________________________________ List sponsored by Redwood Alliance List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org
