Hi All;
We're looking to improve our battery box construction, and are
considering using 1/8" think polypropylene sheeting. I've used small
premade boxes before, but this will be for a HUP install, and we would
want to build the box around the batteries after. Does anyone have
experience/ comments on welding plastic? The alternative would be to
just seal the seams with acid resistant caulking. (silicone, Geocell, ?)
I've had good luck in the past just using 10 mil plastic sheeting
stapled up on the inside of a plywood box, but we will be scooting 1000
lb batteries around on it, so I don't think the sheeting will hold up.
Thanks,
--
R.Ray Walters
CTO, Solarray, Inc
Nabcep Certified PV Installer,
Licensed Master Electrician
Solar Design Engineer
303 505-8760
_______________________________________________
List sponsored by Redwood Alliance
List Address: RE-wrenches@lists.re-wrenches.org
Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive:
http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out or update participant bios:
www.members.re-wrenches.org
