Bob-O, hard to unscrew a rivet.that's a very good suggestion. You would see these holding the modules to bottom clamps instead of bolts? I suspect others on the list have similar problems.
Thanks Bill Dorsett Manhattan, KS (Native word for "the place of great drunkenness") : ) From: re-wrenches-boun...@lists.re-wrenches.org [mailto:re-wrenches-boun...@lists.re-wrenches.org] On Behalf Of Bob-O Schultze Sent: Sunday, October 27, 2013 12:35 PM To: RE-wrenches Subject: Re: [RE-wrenches] Security on a ground mount? 1/4" stainless steel pop rivets are pretty effective. Cost about $1 each and the tool is about $100. Useful for other large rivets as well. You would need a grinder to get them off. Bob-O On Oct 24, 2013, at 1:37 PM, William Dorsett wrote: We've got a system to go up in the student ghetto in the middle of town, so of course we got drunks and little pirates. Height has always been a solution but requires a lot beefier (pronounced "expensive") support pipes. What security measures does everyone recommend of a system that is low enough to unbolt? Thanks all. <image002.jpg> <Bill Dorsett.vcf>_______________________________________________ List sponsored by Home Power magazine List Address: RE-wrenches@lists.re-wrenches.org Change email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out participant bios: www.members.re-wrenches.org <http://www.members.re-wrenches.org/>
_______________________________________________ List sponsored by Home Power magazine List Address: RE-wrenches@lists.re-wrenches.org Change email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out participant bios: www.members.re-wrenches.org