On Mon, 2013-05-06 at 12:06 -0400, David Hays wrote:
> Steve,
> As the Saluki dimensions are similar if not the same as my Homer, should the 
> Honjos, hammered or fluted work with 42mm Hetres with my 56cm 650B Homer?
> Maybe with a bit of trimming?

My Saluki was a 60, and I've never had a close look at any Homer so I'd
be rash if I offered you assurances, although my guess is they'd be
fine.  

Perhaps someone at RBW could speak with authority to this question. 

However, I definitely did need to trim a bit.  I didn't do a very neat
job of it, as you can see here:
http://www.flickr.com/photos/97916047@N00/3522098460/in/set-72157617915097787
and
http://www.flickr.com/photos/97916047@N00/3522098114/in/set-72157617915097787/
but it came as a horrible surprise that I needed to do so and I didn't
really plan it out at all.  I basically just grabbed a saw and had at it
until they fit.  Even so, it still worked out fine and although those
cut edges look close to the chain stays they never made contact.  

Someone planning ahead for this could have made the cuts nicer, and
maybe edged them with some rubbery substance, perhaps RTV sealant.  I'm
not sure if crimping rather than cutting would have done it, because
clearance for a Hetre was pretty close at the chain stays (although
adequate).

-- 
You received this message because you are subscribed to the Google Groups "RBW 
Owners Bunch" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to rbw-owners-bunch+unsubscr...@googlegroups.com.
To post to this group, send email to rbw-owners-bunch@googlegroups.com.
Visit this group at http://groups.google.com/group/rbw-owners-bunch?hl=en-US.
For more options, visit https://groups.google.com/groups/opt_out.


Reply via email to