Straight up in the air- from center of front axle . if there was an imaginary line to top of headset cup- connects at about 58mm. (But measuring up the fork angle to the cup, is about 55.)
>From center of seat tube - just above the seat stay, to center of head tube is about 62.5. On Wed, Sep 9, 2020 at 3:00 AM ☆ Paul ☆ <p...@superplastic.co> wrote: > Hello David and Kim, > > Thanks for your notes, and for the picture and measurements. > > If one of you could do the following measurement for me, I'd be extremely > grateful: > > > - Could you please measure from the center of the front wheel axel a > in straight line to the top of the headset (but not spacers). > - Also could you please measure from the top of the seat tube > (ignoring the little part that pokes out) parallel to the ground to where > your tape measure hits the center of the head tube or stem? Measure from > center of seat tube to center of head tube, if that makes sense. Someone > else emailed me directly and is doing the same for a 56 for me. I'll post > the results for everyone to see, if it's of use! > > > That’s probably all I need. Thank you!!!! > > On Wednesday, September 9, 2020 at 2:41:23 AM UTC-4 Hetchins52 wrote: > >> Paul, >> >> >> Still finishing up my 53 Susie but it’s done enough to give you some >> measurements of head tube versus seat tube heights: >> >> >> The head tube itself is 23 cm long but I don’t have a Clem L for >> comparison. (It is 7 cm longer than the head tube of my 51 Appaloosa.) >> >> >> Measuring from the top of the headset’s locknut to the ground is 95 cm. >> >> >> I’ve installed a 10 cm Nitto DirtDrop stem and, at close to max >> extension, that puts the bar center at about 110 cm from the ground. >> >> >> Measuring from the top of the seat cluster lug (ignoring the pointy bit) >> to the ground is 81 cm. >> >> >> With the saddle at 73 cm extension from the bottom bracket center, saddle >> center is 99 cm to the floor. >> >> >> I'm 5' 8 ½" and my PBH is about 83 cm. >> >> >> [Measurements are approximate….] >> >> >> I’ll take it outside and take a picture tomorrow. >> >> David Lipsky >> Berkeley, CA >> >> On Tuesday, September 8, 2020 at 5:04:05 PM UTC-7, ☆ Paul ☆ wrote: >>> >>> ..... >> >> > > > > > > > > -- > > > You received this message because you are subscribed to the Google Groups > "RBW Owners Bunch" group. > > > To unsubscribe from this group and stop receiving emails from it, send an > email to rbw-owners-bunch+unsubscr...@googlegroups.com. > > > To view this discussion on the web visit > https://groups.google.com/d/msgid/rbw-owners-bunch/2d4e0e2d-3b49-4af2-bcd7-077b855169ccn%40googlegroups.com > <https://groups.google.com/d/msgid/rbw-owners-bunch/2d4e0e2d-3b49-4af2-bcd7-077b855169ccn%40googlegroups.com?utm_medium=email&utm_source=footer> > . > > > -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to rbw-owners-bunch+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/rbw-owners-bunch/CAG55tTZAXXbgZ-1%3DyKQfjYMNRcaKXT2YasC3KG%2BEcTKxCHMsmA%40mail.gmail.com.
