"Dennis Lee Bieber" <wlfr...@ix.netcom.com> wrote in message news:mailman.687.1314941410.27778.python-l...@python.org... > On Thu, 1 Sep 2011 12:30:43 +0200, "Fokke Nauta" > <fnaut...@spamsolfon.nl> declaimed the following in > gmane.comp.python.general: > >> "Dennis Lee Bieber" <wlfr...@ix.netcom.com> wrote in message >> news:mailman.643.1314851358.27778.python-l...@python.org... > >> > Next, if you'd read further and didn't take the comment as the >> > instruction. set >> > firstrun=1 >> >> I did >> >> > to tell the server this is the first time it is being run - IT WILL >> > create the database table (after the first start, reset the flag to 0 >> > to >> > speed up later runs). >> >> It didn't create the table. The database kept empty. > > Odd -- but then, I'm not running it myself, and wasn't up to reading > all the code to see what path it takes.
It's only for experimenting with calendar software, so authorization is not a point. So I forget about MySQL. >> >> > Later in the config file set >> > mysql_auth=1 >> > to enable the use of MySQL, and set the admin user/password to what you >> > plan to have it use. >> >> I did >> >> > You probably want to set >> > daemonize=1 >> > (maybe after first run) >> >> I left this to 0. >> >> > Oh, and don't forget to set the main data directory and any >> > port/host changes. >> >> I left host and port as they were. The main directory is e:\wwwroot >> >> > Start the server - it should connect to MySQL, create the table, and >> > add the admin user to the table. >> >> I started the server with server.py (in >> D:\Python27\WebDAV\PyWebDAV\DAVServer) -D e:/wwwroot -m -c config.ini >> > If the main directory is already in the config file, you probably > don't need to specify it on the command line... OK > And... could there be > something in the code where overriding the directory by command line > changes where it looks for the config file? (Just guessing at this > point). > Possibly. I tried this: server.py -n -c config.ini Once again, the server is up and running and when I am logging in with my browser (10.0.0.140:8081) I can see information showing up at the command prompt, showing somebody is logging is, but the same error: "fshandler:get_data: \Webdav not found". During starting up the server mentioned: "pywebdav:Serving data from \Webdav". In the config file it says: "# main directory directory = \Webdav" Perhaps my Python configuration is at fault. Fokke -- http://mail.python.org/mailman/listinfo/python-list
