Rich <[EMAIL PROTECTED]> wrote: > I am working on a python library for sending and receiving data > from a Subaru's ECU (the fuel injection computer) via the OBD-II > port and an OBD to USB cable, with the Subaru Select Monitor > protocol. [snip] > So I've been messing with it, and in as few lines as possible, this > should in theory, send the init command to the ECU (0x80 0x10 0xF0 > 0x01 0xBF 0x40), and the ECU should return its ID to let you know > that you can now chat (something like 0x80 0xF0 0x10 0x39 0xFF 0xA2 > 0x10 0x0F 0x1B 0x14 0x40 0x05 0x05 0x73 0xFA 0xEB ......):
> > #-------------------------- > import serial, string > output = " " > ser = serial.Serial('/dev/ttyUSB0', 4800, 8, 'N', 1, timeout=1) > ser.write(chr(0x80)+chr(0x10)+chr(0xF0)+chr(0x01)+chr(0xBF)+chr(0x40)) > while output != "": > output = ser.read() > print hex(ord(output)) > #-------------------------- The code looks OK. With a constructor which takes as many arguments as Serial does I tend to name them to avoid mistakes, eg serial.Serial("/dev/ttyUSB0", baudrate=4800, bytesize=8, parity='N', stopbits=1, timeout=1) 8N1 is documented as the default so you could then reduce it to the following if you wanted serial.Serial("/dev/ttyUSB0", baudrate=4800, timeout=1) > The only problem is that when I send the ECU init command, it just > echos back the data I sent it, which, from my understanding, means > that I sent an invalid request packet. My experience with these sort of protocols is that if you make a packet error (wrong address, wrong checksum, wrong start byte) you'll get no reply at all. If you make a command error (use a command that isn't understood in a valid packet) you'll get a properly formatted reply with an error message in. This should start 0x80 0xF0 0x10 .... (from and to reversed). I'd suspect that if you are just receiving the data back then you have got your serial cable wrong and have somehow looped tx and rx. Did you try your cable with the other programs? Or possibly you are using the wrong serial port - are you sure you haven't any other USB serials? ls /dev/ttyUSB* on a udev system will show you. lsusb (as root) is useful as is dmesg immediately after plugging the port in. I do a lot of this sort of thing at work (not with cars though with satellite equipment) and it is always the first packet and the first response which is the hard part. After that it is usually plain sailing! -- Nick Craig-Wood <[EMAIL PROTECTED]> -- http://www.craig-wood.com/nick -- http://mail.python.org/mailman/listinfo/python-list