I've installed PyMol 0.86 on multiple macs according to the instructions of Yuiwho/Bill Scott. It works beautifully except that identical ray tracings now take at least 10 times as long relative to the previous version, or to 0.86 on my PC (system specifics below). 1-2 minutes was a reasonable wait, but 30-40 minutes is just too long. There was mention on this mail list of Povray dependency failures, but at least as far as I can tell, nothing like this was an issue during installation.
Has this been a problem for anyone else? Thanks, Mark Slow: Pymol 0.86 on 12" PowerBook G4 (867 MHz/640 MB RAM), OS 10.2.4 Pymol 0.86 on 15" PowerBook G3 (400 MHz/256 MB RAM), OS 10.2.3 Fast: Pymol 0.84 on 15" PowerBook G3 (400 MHz/256 MB RAM), OS 10.2.3 Pymol 0.86 on Dell PC (600 MHz/256 MB RAM), Windows 2000 Pymol 0.82 on 15" PowerBook G3 (400 MHz/256 MB RAM), OS 10.2.3 ************************************ Mark Hilgers, Ph.D. Syrrx, Inc. 10410 Science Center Drive San Diego, CA 92121 Phone: (858) 731-3570 Mobile: (858) 442-0754 Fax: (858) 550-0526 E-mail: mark.hilg...@syrrx.com ************************************ ---------- This message contains confidential information and is intended only for the individual named. If you are not the named addressee you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. If verification is required please request a hard-copy version.
