You can't change the IDE bus speed. It's set to 33Mhz (66Mhz if you have a MBrd with 64Bit slots). The 266Mhz bus speed you are refering to is the CPU-Memory Bus, and the board will run at that speed without problems.
However the IDE bus TRANSFER rate can be changed using hdparm (--help for parameters) Wolf -----Original Message----- From: Christopher Taylor [mailto:[EMAIL PROTECTED]] Sent: Sunday, 1 December 2002 11:54 AM To: [EMAIL PROTECTED] Subject: IDE Bus Speed In reading the boot information for my RH8 system, I noticed that the system defaults to 33MHz. It also says to set it using IDEBUS=XX. Where do I set it at (I assume in grub.conf, correct?) and what are the limitations of it (i.e. I've got a 266 MHz system bus....can I set it that fast?) Any input would be greatly appreciated.....just learning Linux, and need to tweak the machine out for UT2K3. Thanks in Advance! Chris ###################################################################### Attention: This e-mail message is privileged and confidential. If you are not the intended recipient please delete the message and notify the sender. Any views or opinions presented are solely those of the author. This e-mail has been scanned and cleared by MailMarshal www.marshalsoftware.com ###################################################################### -- Psyche-list mailing list [EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/psyche-list
