----- Original Message ----- From: "Robert M. Wolfe" <[EMAIL PROTECTED]> To: "Protel EDA Forum" <[EMAIL PROTECTED]> Sent: Sunday, November 03, 2002 1:22 PM Subject: Re: [PEDA] Silkscreen over pads
> To All, > Just a thought. > If there is no means of DRC'ing silkscreen > with repsect to pads (or anything else for that matter) > then WHY is it that Protel runs a DRC (which does > take a few seconds) eveytime a Ref Des on Silkscreen > layer is moved???? It's not an electrical item yet > I see it annalizing VCC everytime I move a Ref Des > on a part that is has connections to power (most parts) > on a big board where planes are complete etc. > Sure makes ya wonder. > Seems to waste a bit of time for checking what > at that moment???? > Bob Wolfe I'd imagine that Protel will be programmed such that any change to a part (including it's silkscreen) will cause a DRC to occur. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:proteledaforum@;techservinc.com * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:ForumAdministrator@;TechServInc.com * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@;techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
