.......and change the room definition properties "keep components out" - via right mouse click on room in question, or through design rules > placement > room definition.
----- Original Message ----- From: "Thomas" <[EMAIL PROTECTED]> To: "'Protel EDA Forum'" <[EMAIL PROTECTED]> Sent: Thursday, November 01, 2001 2:08 PM Subject: Re: [PEDA] Clearance from edge of board > Create a Room Definition (design rules/placement). > > > -----Original Message----- > > From: Wayne Trow [mailto:[EMAIL PROTECTED]] > > Sent: Thursday, 1 November 2001 11:55 AM > > To: [EMAIL PROTECTED] > > Subject: [PEDA] Clearance from edge of board > > > > > > Hi All > > > > Im sure this one has been touched before. > > > > I need to create two strips on either end of a board that are > > completely > > void of components. Its ok to place traces in these areas but not > > components. > > > > How do I set up a design rule to check for violations? > > > > I could draw keep outs but that would keep out traces as well > > - which is > > what I dont want. > > > > Thanks in Advance > > > > Wayne Trow > > Gallagher Group LTD > > Hamilton > > New Zealand > > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
