Create a Room Definition (design rules/placement). > -----Original Message----- > From: Wayne Trow [mailto:[EMAIL PROTECTED]] > Sent: Thursday, 1 November 2001 11:55 AM > To: [EMAIL PROTECTED] > Subject: [PEDA] Clearance from edge of board > > > Hi All > > Im sure this one has been touched before. > > I need to create two strips on either end of a board that are > completely > void of components. Its ok to place traces in these areas but not > components. > > How do I set up a design rule to check for violations? > > I could draw keep outs but that would keep out traces as well > - which is > what I dont want. > > Thanks in Advance > > Wayne Trow > Gallagher Group LTD > Hamilton > New Zealand >
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
