Hey there Peter!
On 2/10/2014 11:04 AM, Peter Cushing wrote:
Kurt @ VR-FX wrote:
Hey Folks,
I know I haven't posted on here very much for a while - especially
re:Fox - but, these days I've moved more in the direction of 3D
Printing.
So - I got this Bot - and it prints for an SD Card. Problem is - I
only got 1 PC w/SD Card slot. And, today - upon putting the card in -
its NOT Coming up on the PC (which is actually my old Laptop). Not
sure if there is a true HW problem on the machine. But - unless I can
write to the SD card - I can't even do 3D Printing on my Bot! As such
- I am kinda SOL - and really desperate.
Any suggestions?
Laptop is an OLD Alienware - running Vista.
Does the card show up when you look through my computer?
Nope!
Also check in control panel for Administative tools/computer
management/disk management and you may see it listed there.
Did it - Not listed!
If it is not formatted properly that may be the reason it did not show.
Nope - that's not the problem - as I have been using it - and, when its
in the Bot - it works!
check if the machine can read another card that you know is good.
No can do - I only got 1 SD card right now... :-(
Also check if it has a right protect toggle that may stop you writing
to it.
I just found that toggle on the SD card - but, must say - that can't be
the problem - since I've been writing to the card no problem for a
little while now...
-K-
_______________________________________________
Post Messages to: [email protected]
Subscription Maintenance: http://mail.leafe.com/mailman/listinfo/profox
OT-free version of this list: http://mail.leafe.com/mailman/listinfo/profoxtech
Searchable Archive: http://leafe.com/archives/search/profox
This message:
http://leafe.com/archives/byMID/profox/[email protected]
** All postings, unless explicitly stated otherwise, are the opinions of the
author, and do not constitute legal or medical advice. This statement is added
to the messages for those lawyers who are too stupid to see the obvious.
