Doug Hardie:
> > On 22 April 2018, at 05:50, Wietse Venema <[email protected]> wrote:
> >
> > Doug Hardie:
> >> I understood from the dnsblog man page that each dnsblog process
> >> only lives for a "limited amount of time". I noticed this because
> >> I have over 50 dnsblog processes running on a fairly light duty
> >> postfix server. Some of them are over a week old. At first I
> >> thought they must have been orphaned, but looking through maillog,
> >> I find entries in the last few minutes from the oldest and the
> >> newest. I didn't check all of them, but it appears they are all
> >> in use. Looking at the source for postfix-3.3-20180114 (on web),
> >> it appears dnsblog checks one IP address and then exits. I believe
> >> I can limit the number of dnsblog processes in master.cf (currently
> >> set to 0), but I am not sure that is a good idea. How long are
> >> these processes supposed to live?
> >
> > According to source, dnsblog processes exclude themselves from the
> > max_use limit (max_idle remains in effect). I suppose I turned off
> > max_use because these processes are postscreen helpers. Postscreen
> > was designed to handle a much larger client load than to the rest
> > of Postfix. Under extreme loads like 10000+ connections/second,
> > one does not want to be creating 100+ processes/second, as that
> > would limit scalability.
> >
> > The dnsblog processes still terminate after 100s idle time. On my
> > lightly-loaded server, there currently is no dnsblog process running.
I think that we can avoid the need for warnings in documentation,
by making the dnsblog service act according to the spirit of the
max_idle and max_use settings, even if it cannot act by the letter.
With a given max_idle and max_use setting, a process is expected
to terminate within approximately (max_idle * max_use) seconds.
That is, on a low-volume (but not too low) server, a process may
hang around for a few hours (100*100 = 10000 seconds).
Even if the dnsblog process cannot enforce max_use literally (because
dbsnlog may have to handle a huge number of requests during peak
load), the process could still retire voluntarily after (max_idle
* max_use) seconds, without any negative performance impact.
I'll look into implementing that.
Wietse