Hello again
Ok, I figured out why there are two columns - it has to do with the
special Denon format which inverts the command in a second
transmission.
So the full IR signal is 5 bits address then 10 bits command, a gap,
then the address again and the command inverted.
IR Blaster doesn't support the two columns but it should be able to
invert part of the signal by using a toggle mask.
Please give this a try:
Code:
--------------------
begin remote
name MyRemote
bits 15
flags SPACE_ENC|CONST_LENGTH
eps 30
aeps 100
one 237 1862
zero 237 813
ptrail 241
gap 67300
toggle_bit_mask 0x0
TOGGLE_MASK 0X3FF
MIN_REPEAT 2
begin codes
PowerAmp_On 0x2024
PowerAmp_Off 0x2024
Volume_Up 0x22C4
Volume_Down 0x20C4
end codes
end remote
--------------------
Cheers
Felix
Programming is the art of cleverly arranging bits and bytes. - (c) Felix
Mueller
------------------------------------------------------------------------
fcm4711's Profile: http://forums.slimdevices.com/member.php?userid=42
View this thread: http://forums.slimdevices.com/showthread.php?t=101774
_______________________________________________
plugins mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/plugins
