Hi,
I recently purchased a used touch. I'm quite happy with it, but I can't
have IR Blaster working.
I also have a SB3 and I could use IR blaster with the "IR learning"
plugin and it's so convenient to change the volume, turn on and off from
the SB remote or from LMS !
But this doesn't work with the touch, as the IR blaster touch module
can't use raw codes.
I have an old Denon PMA-980R amplifier with a remote ref RC-151. I
didn't found the conf file on the lirc internet page.
So i tried to do myself the conf file.
As I didn't had a IR receiver, I bought a usb IR receiver
(http://www.mediahd.fr/index.php?id_product=14&controller=product),
sorry the page is in french, and I managed to record a conf file with
irrecord.
I used that command line :
Code:
--------------------
# irrecord --device=/dev/lirc0 --disable-namespace MyRemote
--------------------
I get this basic conf file, just to try :
Code:
--------------------
begin remote
name MyRemote
bits 15
flags SPACE_ENC|CONST_LENGTH
eps 30
aeps 100
one 237 1862
zero 237 813
ptrail 241
gap 67300
toggle_bit_mask 0x0
begin codes
PowerAmp_On 0x2024 0x23DB
PowerAmp_Off 0x2024 0x23DB
Volume_Up 0x22C4 0x213B
Volume_Down 0x20C4 0x233B
end codes
end remote
--------------------
IR blaster plugin accept this conf file, but nothing appends when I test
it.
I tried this file with the touch and the SB3 and this is the same,
nothing works.
I was wondering if the conf file would be of RC6 codes, as IR blaster
for the touch only supports RC5 codes.
So, I tried to configure the IR receiver for RC5.
If I run
Code:
--------------------
# ir-keytable
Found /sys/class/rc/rc0/ (/dev/input/event13) with:
Driver mceusb, table rc-rc6-mce
Supported protocols: NEC RC-5 RC-6 JVC SONY SANYO LIRC other
Enabled protocols: NEC RC-5 RC-6 JVC SONY SANYO LIRC other
Name: Media Center Ed. eHome Infrared
bus: 3, vendor/product: 147a:e03e, version: 0x1201
Repeat delay = 500 ms, repeat period = 125 ms
--------------------
and then :
Code:
--------------------
# ir-keytable -p RC5 -s rc0
Protocols changed to RC-5
--------------------
But then if I try to capture again the codes with irrecord, there is no
data and it aborts.
I'm stucked now, I don't know what to do !
Thanks a lot for help.
------------------------------------------------------------------------
Antoniop's Profile: http://forums.slimdevices.com/member.php?userid=39292
View this thread: http://forums.slimdevices.com/showthread.php?t=101774
_______________________________________________
plugins mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/plugins
