SamY wrote: > The receiver is not responding to a request for the power status of the > Zone 2 amp. Since the plugin does work if the receiver is already turned > on, and powers it off successfully, I would suspect that the receiver is > not set up to stay powered on in standby mode, which is a requirement of > using network control to turn it on. Here are the instructions for > setting this on your AVR: > > I hope this helps.
Bingo! An overlooked setting on that amp, but for some reason I had it correct on the other amp! Thank you very much for sorting that one out for me, very much appreciated. One less life aggravation to put up with! LOL Cheers, David *Server*rpi3 pCP5.0.1 LMS7.9.2 *Media*USB hard drive *Lounge/dining areas*SBT > Denon AVR2113 > Bose Acoustimass10 / Krix Seismix3 18" 300w RMS custom cinema sub (& AR 77XB t/table, Stanton 680MkII / Grado F-1+ > NAD7155 to phono pre-amp > Amp+) *Family/kitchen*SBT > Denon AVRX3000 zone 1 > Krix Acoustix F, Centrix C, Holographix R & Original Seismix 7 15" 400w RMS sub *Alfresco*as above zone 2 > Krix Tropix *Others*SB Player/androids > Bose Soundlink Mini *SBT/SB Player Remotes* Squeeze Ctrl/androids ------------------------------------------------------------------------ DavidBulluss's Profile: http://forums.slimdevices.com/member.php?userid=60056 View this thread: http://forums.slimdevices.com/showthread.php?t=60114 _______________________________________________ plugins mailing list plugins@lists.slimdevices.com http://lists.slimdevices.com/mailman/listinfo/plugins
