I'm not certain that I can make this statement unequivocal, so note the qualifiers <g>
It seems that the developer temperature creeps up a bit during the course of the process. I sometimes measure the temp at intervals during the processing, and, IIRC, not having made any notes, every time I've measured the temperature it's a bit higher at the end of the process than at the beginning. While handling the tank may contribute some to this, I wonder how much heat the chemical process puts out, and if that could be a factor in the upward temperature creep? OTOH, I am very careful about handling the tank, and do so only minimally and at the edges or by the securing ring around the cap. I also wonder if a water bath would mitigate the increase. Aaron Reynolds wrote: > Yes. Here I'm talking about temperature dropping over the course of the > fixing, or cooling slightly as it sits. I am not talking about radical > changes in temperature. -- Shel Belinkoff mailto:[EMAIL PROTECTED] http://home.earthlink.net/~belinkoff/ - This message is from the Pentax-Discuss Mail List. To unsubscribe, go to http://www.pdml.net and follow the directions. Don't forget to visit the Pentax Users' Gallery at http://pug.komkon.org .
