Hi, this is mostly for archives, if somebody is asking about
good and cheap and powerful TTL flash in the future he can just read
this <g> so we can concentrate on more important threads like
"Chemical vs. Digital"; Paal/Pel/Pol; What is Pentax ;-)). About an
inexpensive but powerful and very capable flash.
As I couldn't find any web information on the flash when I was
deciding if to buy it, I wrote this for others who might
be seeking info on it.
I got the 35ct2 after I sold a Sunpak big handlemount flash which was just too big and
heavy
for lugging around. Coming from a GN 45 (m) (@ 35mm lens coverage) flash I wanted a
powerful flash but _smaller_ than the big Sunpak G4500DX/AT555.
The 35ct2 has GN 35 (m) at 35mm lens (in reality slightly wider coverage, around
30mm),
which is same as Vivitar 283 and other highly regarded flashes.
The GN 35 flash is about 0.7 f/stop less powerfull than GN 45
"potato-masher" style flash, but much easier to carry around.
In fact, it is as powerful as 40MZ or Pentax
500FTZ, only lacking a zoom head (which is used to inflate GN.
500FTZ's GN 50(m) is stated at 85mm zoom, Metz's GN 40 is stated at
50mm zoom. "Ages" old flash standard coverage for computing GN is 35mm
lens). On modern cameras, AF assist, 2nd curtain, program flash,
fill-in program flash (depending on camera), maybe more, all should be
possible with SCA adapter 374 AF/2. I have to check this though when I
get the 374 :).
Only problem is this flash uses flashead which has
filterholder not compatible with MZ series flashes, thus more limited
filter accessories (only ND filters and Wide - 28mm - were made I
think). All 300 series and some 3000 series accessories which mount on
SCA shoe are usable, even powergrip G15 (which allows for connection
of 3000 series adapter! Yup, the flash sits on barefoot G15, and from
G15 a 3000C cord goes to SCA 3000/3002 adapter on camera's hotshoe.
Unlike the Metz's MZ series, the CT and CL series flashes' GN is for 35mm
coverage, thus you can immediately see the flash's power by seeing its
number - 32 CT has GN 32, 35 CT has GN 35, 45 CL has gn 45.
User interface - very simple. Switch for mode selection - 3 auto
(f2,f4,f8 apertures at 100 iso), manual, ttl. Above it is Exposure
OK Check light. At top of back panel is f/stop & distance calculator,
where you set iso and see instantly color-coded auto f/stops as well
as maximum TTL/manual distance at any aperture. Better than fancy
LCDs. There is also battery check button and light, fairly useful.
Also a TEST button which fires the flash, near it is flash ready
light. The on/off is little strange, there are two separate buttons
for On and Off, making accidental Ons a little easier :(. At least the
flash has auto-power-off in about 5 minutes of non-use, so it won't
drain the batteries even if set in camera bag when On. I prefer
sliding switches to buttons though.
Head is tilt, up to 90 degrees, in these click-positions: straight,
60,70,80,90 degree. None confusing 30, 45 degree positions which I never
used. The whole flash swivels for vertical bounces (the AF assist SCA
and auto-sensor doesn't swivel, for obvious reasons).
Recycle - from 4 AA NiCd 850mAh cells, recycle times are about 3
seconds on fresh batteries to 4 seconds average. With my 5 cell
(rebadged from notebook) NiMH 3500mAh battery pack, recycle is only 1-1.5 seconds at
full power!!! That's quick enough to overheat the flash if you do
20-30 full discharges without letting it cool down.So recycle times are very good. If I
had 3500mah _NiCd_ cells (instead of NiMH) in the pack, recycle would be even
shorter!!! Why I used 5
cell pack when flash is rated at 4 cells ? 5 rechargables roughly
equate voltage of 4 alkalines, which have 1.5 voltage average compared
to 1.2 average of NiMH/NiCd. Also, higher voltage combined with very
good recycletime characteristics inherent in NiCd/NiMH (versus
Alkalines, which have bad recycletime characteristics) gives me even
lower recycletime than with 4 rechargables. Of course, it's maybe
pushing the limits of the flash, but especially in older designs there
was enough leeway I think.
A big plus is that the circuitry used to make direct current into
alternating current is very SILENT, with NO UGLY BUZZING SOUND as
other flashes do, even if used with my battery pack! The Sunpak did a lot of
buzzing... But even still the start of charging is audible, giving you
audible confirmation of full discharge. That's good! I hated the
buzzing, although it was very positive at times.
Most Metzes are VERY rugged, my friend's 32MZ3 fell down from 2m on
rocks, it broke open into two parts, he just clicked the shell into
one part again and it worked again...
Drawbacks - slightly strange separate on/off buttons which are
somewhat easier to set on if not wanted than a switch. At least the
flash has "screensaver" timer builtin.
- absence of filters, especially tele-attachments. None were
made for this or similar flashes AFAIK. That's a major pity
because its high guidenumber is very suitable for use with such
attachments in bird and nature tele photography. Of course you
can adapt one using velcro and tape...
Overall, this flash (and propably other shoe-mounted CT and CL series
flashes, SCA 300) can give very good performance. In many aspects
including power, it's on par with flashes now costing several times
more like 40MZ3 and 500FTZ (40MZ costs used around 2.5-3.5x more, 500FTZ
cost used 5x more). It can even give you digital flash features
through use of SCA 374AF, though this has yet to be confirmed in
practice if this model supports all the features (Metz's website
doesn't tell :(
Frantisek
-
This message is from the Pentax-Discuss Mail List. To unsubscribe,
go to http://www.pdml.net and follow the directions. Don't forget to
visit the Pentax Users' Gallery at http://pug.komkon.org .