josvdh wrote:
The socket is located in the base at the rear, close to the hole for the tripod. It could be custom made, but very well done. The socket is not a mini jack, but a kind of flash connector, the cable of the databack fits in it, but I cannot think of that being a logical connection! The socket does not have a nut on the outside as would be the case with a "home made" connection. I will try to mail a picture. And I will check the internal connection. Jos
-----Oorspronkelijk bericht----- Van: graywolf [mailto:[EMAIL PROTECTED] Verzonden: Thursday, January 22, 2004 1:23 AM Aan: [EMAIL PROTECTED] Onderwerp: Re: two different winders for MX
A 1/8" mini-jack on the top outside of the grip was the factory remote madification. could you post a link to a photo?
-
josvdh wrote:
Dear group, Recently I aquired a beautifull MX with databack and winder. They are in splendid condition exept for the sticky foam.... Comparing the winder with the winder that I had already I noticed a difference: the latest has a socket on the rear side. Maybe for a remote control?? The Boz site has no info on this. Who knows about the function of this socket?
Regards, Jos van der Hijden
-- graywolf http://graywolfphoto.com
"You might as well accept people as they are, you are not going to be able to change them anyway."
-- graywolf http://graywolfphoto.com
"You might as well accept people as they are, you are not going to be able to change them anyway."
