Thanks, but the response to this is "Page cannot be displayed" Bill
----- Original Message ----- From: "Caveman" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, June 10, 2003 6:31 PM Subject: Re: Computer to the shop? or can one of you gurus figure it out > You might need "better" drivers for your USB card. I suspect you have a > VIA chip based one, look at www.via.co.tw for updates. > > Bill Owens wrote: > > Last week I installed a USB 2.0 card to run my new Epson 3200 scanner. > > Everything works well unless I turn the scanner off with the computer on, > > then I get a crash with the following response: > > > > KEBUGCHECKEX: Called by c00029e58 > > ERROR CODE IS 44 > > Parameters: e13fac40 0 0 0 > > > > System Halted. > > > > Today the Optio S arrived and with the software loaded, if I turn the camera > > on the system crashes with the familiar Windoz "An error has occurred" This > > one is from : > > > > File Name: vobiw(01) + 0001F07A > > Error: 0E: 0O28: C19b321A > > > > I think the machine goes to the local Best Buy tomorrow morning. > > > > Bill > > > > > > > >
