On Thu, May 19, 2016 at 06:19:35PM +0200, Mathias Kresin wrote: > I found the pins to enter UART boot mode. Apply 3,3V to the right side > of R65 and GND to the right side of R80. > :)
> R80 is partially hidden under the heatsink of the SoC. > not in my case - clearly, the glueing of the heatsinks isn't exactly precision work. in fact, only the crystal next to the ram stopped the sink from sliding off entirely. :D > 2016-05-18 23:00 GMT+02:00 Oswald Buddenhagen <oswald.buddenha...@gmx.de>: > > i'll do that if you don't beat me to it (which you can easily do if you > > plan to seriously work on this - beyond email, this is a limited weekend > > project for me). > > From zero to working image in just a weekend. That is indeed amazing. > well, i didn't say *one* weekend. ;) i spent easily 50 hours on that project, though probably i could have pulled it off in 5 hours if i had known what i'm doing. now i know more about wifi drivers, pci busses and devicetrees than i ever wanted or needed to. :D but i really didn't start from zero - the dts at https://wiki.openwrt.org/toh/arcadyan/arv7506 is almost complete, even if broken in a most sinister way. ^^ > > i think i also know why rfkill doesn't work: i forgot to change the > > keycode when i decided to switch the key's usage from wps to rfkill. > > (facepalm) > > That's something where I've a lack of knowledge. Where does the > keycodes come from? > it's in the devicetree. i sent an updated patch. it's not tested, though. > In the meantime I've added support for this board to u-boot, switched > from brnboot to uImage and to a custom partitions layout with a > firmware partition of 8128 KByte. Means, your image shrinking patches > aren't required any more. > cool. > I haven't had a closer look to the OpenWrt image, but what I've > noticed so far, is a not lit up WLAN led when the wireless is enabled. > Does it work for you? > not out of the box, iirc. i configured it to netdev/wlan0/link+tx+rx, which works fine. this shouldn't be necessary, so a board case should be probably added to /target/linux/lantiq/base-files/etc/board.d/01_leds. just amend my patch and add a footer mentioning your co-authorship. > Do you plan to work further on this patch or do you consider your > weekend project as finished. > i'll happily hand it off at this point. _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
