I'm sorry, i said ath9k in the subject but the above seems more likely to be ath10k.
On Thu, Jul 9, 2015 at 7:03 PM, camden lindsay <camden.lindsay+open...@gmail.com> wrote: > Hello- > > Thought I should report this, since there was so much discussion and > confusion on tracker https://dev.openwrt.org/ticket/11862 causing a > lot of work for some folks here. > > > root@HACKEDBOXII.'xxxx':~# cat /etc/banner > _______ ________ __ > | |.-----.-----.-----.| | | |.----.| |_ > | - || _ | -__| || | | || _|| _| > |_______|| __|_____|__|__||________||__| |____| > |__| W I R E L E S S F R E E D O M > ----------------------------------------------------- > CHAOS CALMER (15.05-rc1, r45695) > ----------------------------------------------------- > * 1 1/2 oz Gin Shake with a glassful > * 1/4 oz Triple Sec of broken ice and pour > * 3/4 oz Lime Juice unstrained into a goblet. > * 1 1/2 oz Orange Juice > * 1 tsp. Grenadine Syrup > ----------------------------------------------------- > root@HACKEDBOXII.'xxxx':~# > > > > > root@HACKEDBOXII.'xxxx':~# iw phy phy1 info > Wiphy phy1 > max # scan SSIDs: 4 > max scan IEs length: 2257 bytes > Retry short limit: 7 > Retry long limit: 4 > Coverage class: 0 (up to 0m) > Device supports AP-side u-APSD. > Device supports T-DLS. > Available Antennas: TX 0x7 RX 0x7 > Configured Antennas: TX 0x7 RX 0x7 > Supported interface modes: > * IBSS > * managed > * AP > * AP/VLAN > * WDS > * monitor > * mesh point > * P2P-client > * P2P-GO > Band 1: > Capabilities: 0x11ef > RX LDPC > HT20/HT40 > SM Power Save disabled > RX HT20 SGI > RX HT40 SGI > TX STBC > RX STBC 1-stream > Max AMSDU length: 3839 bytes > DSSS/CCK HT40 > Maximum RX AMPDU length 65535 bytes (exponent: 0x003) > Minimum RX AMPDU time spacing: 8 usec (0x06) > HT TX/RX MCS rate indexes supported: 0-23 > Frequencies: > * 2412 MHz [1] (23.0 dBm) > * 2417 MHz [2] (25.0 dBm) > * 2422 MHz [3] (25.0 dBm) > * 2427 MHz [4] (25.0 dBm) > * 2432 MHz [5] (25.0 dBm) > * 2437 MHz [6] (25.0 dBm) > * 2442 MHz [7] (25.0 dBm) > * 2447 MHz [8] (25.0 dBm) > * 2452 MHz [9] (25.0 dBm) > * 2457 MHz [10] (25.0 dBm) > * 2462 MHz [11] (24.0 dBm) > * 2467 MHz [12] (disabled) > * 2472 MHz [13] (disabled) > * 2484 MHz [14] (disabled) > valid interface combinations: > * #{ managed } <= 2048, #{ AP, mesh point } <= 8, #{ P2P-client, > P2P-GO } <= 1, #{ IBSS } <= 1, > total <= 2048, #channels <= 1, STA/AP BI must match > * #{ WDS } <= 2048, > total <= 2048, #channels <= 1, STA/AP BI must match > * #{ IBSS, AP, mesh point } <= 1, > total <= 1, #channels <= 1, STA/AP BI must match, radar detect > widths: { 20 MHz (no HT), 20 MHz, 40 MHz } > > HT Capability overrides: > * MCS: ff ff ff ff ff ff ff ff ff ff > * maximum A-MSDU length > * supported channel width > * short GI for 40 MHz > * max A-MPDU length exponent > * min MPDU start spacing > root@HACKEDBOXII.'xxxx':~# > > > ...snip... > ... > [2060235.460000] ath: phy1: Failed to stop TX DMA, queues=0x002! > [2060265.460000] ath: phy1: Failed to stop TX DMA, queues=0x002! > [2061047.180000] ath: phy1: Failed to stop TX DMA, queues=0x002! > [2104015.840000] ath: phy1: Unable to reset channel, reset status -5 > [2145012.920000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2145013.030000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2145013.130000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2145013.230000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2145013.330000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2145013.430000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2145013.540000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2145013.640000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2145013.740000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158242.790000] ath10k_warn: 18 callbacks suppressed > [2158242.800000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158242.890000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158243.000000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158243.100000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158243.200000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158243.300000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158243.410000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158243.510000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158243.610000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158243.710000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158245.620000] ------------[ cut here ]------------ > [2158245.620000] WARNING: CPU: 0 PID: 1302 at > /home/buildbot/slave-local/ar71xx_generic/build/build_dir/target-mips_34kc_uClibc-0.9.33.2/linux-ar71xx_generic/compat-wireless-2015-03-09/net/mac80211/sta_info.c:909 > sta_set_sinfo+0x7f4/0x88c [mac80211]() > [2158245.640000] Modules linked in: pppoe ppp_async iptable_nat ath9k > pppox ppp_generic nf_nat_ipv4 nf_conntrack_ipv6 nf_conntrack_ipv4 > ipt_REJECT ipt_MASQUERADE ath9k_common xt_time xt_tcpudp xt_state > xt_nat xt_multiport xt_mark xt_mac xt_limit xt_id xt_conntrack > xt_comment xt_TCPMSS xt_REDIRECT xt_LOG xt_CT slhc nf_reject_ipv4 > nf_nat_masquerade_ipv4 nf_nat_ftp nf_nat nf_log_ipv4 nf_defrag_ipv6 > nf_defrag_ipv4 nf_conntrack_rtcache nf_conntrack_ftp nf_conntrack > iptable_raw iptable_mangle iptable_filter ip_tables crc_ccitt ath9k_hw > ath10k_pci ath10k_core ath mac80211 cfg80211 compat ledtrig_usbdev > ip6t_REJECT nf_reject_ipv6 nf_log_ipv6 nf_log_common ip6table_raw > ip6table_mangle ip6table_filter ip6_tables x_tables ipv6 arc4 > crypto_blkcipher ohci_platform ohci_hcd ehci_platform ehci_hcd > gpio_button_hotplug usbcore nls_base usb_common > [2158245.720000] CPU: 0 PID: 1302 Comm: hostapd Not tainted 3.18.11 #1 > [2158245.720000] Stack : 00000000 00000000 00000000 00000000 803d4272 > 00000035 00000000 87185e40 > [2158245.720000] 00000001 00000000 80329980 80382ba3 00000516 > 803d349c 86e74bf8 00000000 > [2158245.720000] 00000004 00000000 00000008 800a365c 00000003 > 800803c4 0000038d 00000000 > [2158245.720000] 8032cf78 8729d77c 00000000 00000000 00000000 > 00000000 00000000 00000000 > [2158245.720000] 00000000 00000000 00000000 00000000 00000000 > 00000000 00000000 00000000 > [2158245.720000] ... > [2158245.760000] Call Trace: > [2158245.760000] [<80071058>] show_stack+0x48/0x70 > [2158245.770000] [<800804cc>] warn_slowpath_common+0x84/0xb4 > [2158245.770000] [<80080584>] warn_slowpath_null+0x18/0x24 > [2158245.780000] [<87185e40>] sta_set_sinfo+0x7f4/0x88c [mac80211] > [2158245.780000] > [2158245.790000] ---[ end trace 88b40085bccc396d ]--- > [2158247.910000] ath10k_warn: 41 callbacks suppressed > [2158247.920000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158248.010000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158248.120000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158248.220000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158248.320000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > [2158248.420000] ath10k_pci 0000:01:00.0: SWBA overrun on vdev 0, > skipped old beacon > ...snip... > ... > > I will upgrade to the newest rc i can find and see if I still see issues. > > thanks > Camden _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
