David Lang <da...@lang.hm> wrote:
>> I have stumbed my toe on 3800 with trying to build tagged switch ports
>> where I have a few ports with explicit VLAN tagging, joined together
>> in the switch, and also exposed to the host. I think it should work,
>> but I mostly just wound up screwing up my CPU port. I have some 3800
>> with serial consoles now so I should try this out.
> I've been using tagged and untagged switch ports on the 3800 for a few
> years now (I use them for the Scale conference and we have a rather
> complex wired infrastructure), the only problem I ran into was the
> issue of the ports being numbered backwards on the outside of the box.
The situation which I wanted was to have a port with three or four tagged
interfaces visible to the kernel. Of those tagged LANs, I then wanted to
have some of the visible on another physical port, untagged.
The tagged port goes into a (cisco) SOHO switch, and talks to a bunch of VMs,
etc. The untagged ports get wired to a couple of other "critical" systems:
the other AP in the house, a VoIP phone (via PoE injector). This lets me
put the 3800, and phone on a UPS seperate from the switch and VM hosts.
> For the conference, I use one port on the switch as my WAN port
> (trunked) and then configure the other three ports to specific VLANs. I
> configure the 'wan' port to be trunked as well, but generally only end
> up using it to daisy-chain another AP off of.
So, what I want to do ought to be possible, I've just failed to get it
configure properly.
--
] Never tell me the odds! | ipv6 mesh networks [
] Michael Richardson, Sandelman Software Works | network architect [
] m...@sandelman.ca http://www.sandelman.ca/ | ruby on rails [
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
