On 8 April 2014 16:39, Claudio Leite <lei...@staticky.com> wrote:
> These patches fix Ethernet and wireless on rt2880 boards. I have tested
> on two systems with success.
>
> The last patch is made against Roman Yeryomin's previously-submitted,
> but not yet merged, pinctrl patch.
>
> Note that the board DTS must define the port and PHY to connect to.
> Here's an example for a board connecting to a IP175E 100mbit switch
> at PHY 0:
>
> ethernet@400000 {
> status = "okay";
> mtd-mac-address = <&factory 0x4>;
>
> port@0 {
> phy-handle = <&phy0>;
> phy-mode = "mii";
> };
>
> mdio-bus {
> status = "okay";
> phy0: ethernet-phy@0 {
> phy-mode = "mii";
> reg = <0>;
> };
> };
> };
>
> If necessary, a fixed-link parameter can be specified instead of
> phy-handle/phy-mode:
> port@0 {
> ralink,fixed-link = <100 1 1 1>;
> };
>
> Claudio Leite (4):
> ramips: enable port init function on RT2880 ethernet
> ramips: set wmac clock on rt2880
> ramips: squelch mdio debugging info on rt2880 ethernet
> ramips: add rt2880 ethernet port device type
> _______________________________________________
I can confirm these patches are working with Asus rt-n15.
After these and another one I sent for eeprom extraction are applied
to trunk I will send another one to fix DT for Asus board.
Regards,
Roman
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
