On 4 February 2014 17:56, Helmut Schaa <helmut.sc...@googlemail.com> wrote: >>>> Currently wifi interface appears in the system and can be enabled but >>>> `iw dev wlan0 scan' gives no result and wlan0 transmits one packet >>>> roughly in 10 minutes as per ifconfig (ssid doesn't appear in the >>>> air). >>>> `iw phy' output looks like this: >>> >>> Maybe you should start with a simple monitor interface to get the RX >>> path working (iw phy phy0 interface add mon0 type monitor). >>> Just run a tcpdump on mon0 and see if you can receive something (with >>> your patches applied). >> >> Unfortunately it doesn't give any results. >> Also rx counter was always zero - I forgot to mention that. >> What I thought was suspicious is "Available Antennas: TX 0 RX 0" in iw >> phy output, but I've checked other chips which do work and they all >> have the same record. > > Yeah, rt2x00 does not initialize these AFAIK. > > So, you ported the code from the ralink rt2860 driver, right? > I haven't looked into newer ralink chips at all. Did you check if any MAC > layer changes regarding RX and TX rings exist?
Yes, from rt2860v2 2.7.1.6 to be precise. Yes I did the mac registers init too. There are several new registers they initialize. I tried to integrate mac init to the existing function. Do you think I should try to do it separately? Regards, Roman _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
