On 01/16/2013 09:37 PM, Mathias Adam wrote: > This patch adds support for Huawei E970 wireless gateway devices. > It has been tested on an E970 labelled as T-Mobile web'n'walk Box IV. > E960/B970 should work too, from what I know it's basically the same hardware. > > The device has a Broadcom BCM5354 SoC and a built-in 3G USB modem. > > It uses a hardware watchdog which needs GPIO-7 to be toggled at least > every 1-2 seconds. This patch uses gpio_wdt module (see my previous > patch today) to take care of this. > > Tested and works: 3G wan, wlan+LED, VLAN config, failsafe using reset > button, image to be used for upgrade from OEM firmware's web interface > > Link to the wiki page I've created: <http://wiki.openwrt.org/toh/huawei/e970> > > Issue: > > * lzma-loader crashes, so gzipped kernel is used. Presumably due to watchdog > reset during kernel decompress. > > Signed-off-by: Mathias Adam <m.adam--open...@adamis.de> > > --- > Thank you for the patch.
This was committed in r38001, r38010 and r38011. Instead of doing board detection all over the code the bcm47xx_baord detection is now called. Hauke _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
