It's a "dragino" http://www.dragino.com/ They're also sold by flukso:
https://www.flukso.net/
It's an ar2317. AA and trunk are the same, as this leds change went into trunk
before AA was pulled as a separate branch. I only first tried this board out
with backfire, and the wlan led worked out of the box. I added the sysfs
support in AA/trunk, but I didn't change any of the gpio board setup. I also
don't have any other atheros boards to try out.
If you're planning on doing more work to clean this up, then sure, go ahead, but
in that case, can it all go in together? Does it have to go in part now, and
part later?
Cheers,
Karl Palsson
On 11/21/2012 10:29 PM, Jonathan Bither wrote:
Karl,
I remember attitude adjustment not booting as well with flash errors,
however I can try to rebuild an older backfire checkout and reflash the device
to log the behavior. The revert was intended to be temporary to fix the
regression with devices not booting. I plan on submitting additional patches
that fix the intended behavior. Care to share the model of your device so that I
may get one in to work with?
Thanks,
Jonathan Bither
On 11/21/2012 05:02 PM, Karl P wrote:
I'm still against reverting. What's really needed here is support for
different atheros devices, not just outright dropping led support. Currently,
the gpio setup is fixed for all devices, which clearly isn't ok.
Sure, I admit that not booting your device is worse than my leds not working,
but tossing it all out doesn't really seem like the right way forward. What
was the backfire behaviour on your device? Ours had a working wifi light, and
the gpio hasn't changed, so I'm surprised that it's only _just_ started being
problems.
Cheers,
Karl P
On 11/21/2012 09:03 PM, Jonathan Bither wrote:
v2: explicitly unset CONFIG_LEDS_GPIO
It causes flash access errors on devices that use a non-standard gpio line line
to control the spi flash chip select. Fixes a handful of open tickets.
First resolved in changeset # 16765
Signed-off-by: Jonathan Bither <jonbit...@gmail.com>
---
target/linux/atheros/base-files/etc/uci-defaults/leds | 11 -----------
target/linux/atheros/config-3.3 | 4 ++--
2 files changed, 2 insertions(+), 13 deletions(-)
delete mode 100644 target/linux/atheros/base-files/etc/uci-defaults/leds
diff --git a/target/linux/atheros/base-files/etc/uci-defaults/leds
b/target/linux/atheros/base-files/etc/uci-defaults/leds
deleted file mode 100644
index 076a04b..0000000
--- a/target/linux/atheros/base-files/etc/uci-defaults/leds
+++ /dev/null
@@ -1,11 +0,0 @@
-#!/bin/sh
-# Copyright 2012 OpenWrt.org
-#
-
-. /lib/functions/uci-defaults.sh
-
-ucidef_set_led_netdev "wlan" "wlan" "wlan" "wlan0"
-
-ucidef_commit_leds
-
-exit 0
diff --git a/target/linux/atheros/config-3.3 b/target/linux/atheros/config-3.3
index 9f68b4e..39d8716 100644
--- a/target/linux/atheros/config-3.3
+++ b/target/linux/atheros/config-3.3
@@ -35,7 +35,7 @@ CONFIG_GENERIC_ATOMIC64=y
CONFIG_GENERIC_CLOCKEVENTS=y
CONFIG_GENERIC_CLOCKEVENTS_BUILD=y
CONFIG_GENERIC_CMOS_UPDATE=y
-CONFIG_GENERIC_GPIO=y
+# CONFIG_GENERIC_GPIO is not set
CONFIG_GENERIC_IRQ_SHOW=y
CONFIG_GENERIC_PCI_IOMAP=y
CONFIG_GPIOLIB=y
@@ -70,7 +70,7 @@ CONFIG_INITRAMFS_SOURCE=""
CONFIG_IP17XX_PHY=y
CONFIG_IRQ_CPU=y
CONFIG_IRQ_FORCED_THREADING=y
-CONFIG_LEDS_GPIO=y
+# CONFIG_LEDS_GPIO is not set
CONFIG_MDIO_BOARDINFO=y
CONFIG_MIPS=y
CONFIG_MIPS_L1_CACHE_SHIFT=5
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel