I can confirm that this issue effects EnGenius ECB-3500 as well.
On 08/27/2012 09:24 AM, Karl Palsson wrote: > > I think this really just means that the Atheros platform needs to be broken > up into separate boards, > like ar71xx and other newer platforms. Currently allll Atheros targets get > the same init code, and > clearly your board needs different init code to mine :) > > Cheers, > Karl P > > On Sun, Aug 26, 2012 at 10:13:33PM -0500, Ben West wrote: >> This changeset on trunk appears to prevent booting up on a OM1P >> (Atheros AR2315). That is, freshly compiled r32884 boots fine on >> OM1P, but flashing the device with r32885+ leads to unresponsive eth0 >> interface on OM1P. I am lacking a TTL/serial cable, so I can't share >> more information. >> >> https://dev.openwrt.org/changeset/32885/trunk >> >> Removing the line CONFIG_LEDS_GPIO=y from >> target/linux/atheros/config-3.3 and recompiling leads to booting >> firmware again. >> >> Since this is related to kernel GPIO LED control, I posted a bug >> earlier this summer about a compile problem witnessed with >> kmod-leds-gpio package for ath5k, but I had no patch to offer. >> Perhaps, these problems are related? >> >> https://dev.openwrt.org/ticket/11797 >> >> If not related, I do see CONFIG_LEDS_GPIO being unset in this >> changeset from several years ago, with the comment specifically >> referring to flash access errors. Is changeset r32885 a regression >> then? >> >> https://dev.openwrt.org/changeset/16765/ >> >> On Fri, Jul 6, 2012 at 7:32 AM, Karl Palsson <ka...@tweak.net.au> wrote: >>> From: Karl Palsson <ka...@remake.is> >>> >>> atheros trunk moved to full sysfs gpiolib, but the leds were forgotten. >>> This restores the wlan led that was missing after switching from backfire >>> to trunk. >>> >>> Signed-off-by: Karl Palsson <ka...@remake.is> >>> --- >>> .../linux/atheros/base-files/etc/uci-defaults/leds | 11 +++++++++++ >>> target/linux/atheros/config-3.3 | 1 + >>> 2 files changed, 12 insertions(+), 0 deletions(-) >>> create mode 100644 target/linux/atheros/base-files/etc/uci-defaults/leds >>> >>> diff --git a/target/linux/atheros/base-files/etc/uci-defaults/leds >>> b/target/linux/atheros/base-files/etc/uci-defaults/leds >>> new file mode 100644 >>> index 0000000..076a04b >>> --- /dev/null >>> +++ b/target/linux/atheros/base-files/etc/uci-defaults/leds >>> @@ -0,0 +1,11 @@ >>> +#!/bin/sh >>> +# Copyright 2012 OpenWrt.org >>> +# >>> + >>> +. /lib/functions/uci-defaults.sh >>> + >>> +ucidef_set_led_netdev "wlan" "wlan" "wlan" "wlan0" >>> + >>> +ucidef_commit_leds >>> + >>> +exit 0 >>> diff --git a/target/linux/atheros/config-3.3 >>> b/target/linux/atheros/config-3.3 >>> index be0c74a..c3713b3 100644 >>> --- a/target/linux/atheros/config-3.3 >>> +++ b/target/linux/atheros/config-3.3 >>> @@ -70,6 +70,7 @@ CONFIG_INITRAMFS_SOURCE="" >>> CONFIG_IP17XX_PHY=y >>> CONFIG_IRQ_CPU=y >>> CONFIG_IRQ_FORCED_THREADING=y >>> +CONFIG_LEDS_GPIO=y >>> CONFIG_MDIO_BOARDINFO=y >>> CONFIG_MIPS=y >>> CONFIG_MIPS_L1_CACHE_SHIFT=5 >>> -- >>> 1.7.2.5 >>> >>> _______________________________________________ >>> openwrt-devel mailing list >>> openwrt-devel@lists.openwrt.org >>> https://lists.openwrt.org/mailman/listinfo/openwrt-devel >> >> >> >> -- >> Ben West >> http://gowasabi.net >> b...@gowasabi.net >> _______________________________________________ >> openwrt-devel mailing list >> openwrt-devel@lists.openwrt.org >> https://lists.openwrt.org/mailman/listinfo/openwrt-devel > _______________________________________________ > openwrt-devel mailing list > openwrt-devel@lists.openwrt.org > https://lists.openwrt.org/mailman/listinfo/openwrt-devel > _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
