I think this really just means that the Atheros platform needs to be broken up into separate boards, like ar71xx and other newer platforms. Currently allll Atheros targets get the same init code, and clearly your board needs different init code to mine :)
Cheers, Karl P On Sun, Aug 26, 2012 at 10:13:33PM -0500, Ben West wrote: > This changeset on trunk appears to prevent booting up on a OM1P > (Atheros AR2315). That is, freshly compiled r32884 boots fine on > OM1P, but flashing the device with r32885+ leads to unresponsive eth0 > interface on OM1P. I am lacking a TTL/serial cable, so I can't share > more information. > > https://dev.openwrt.org/changeset/32885/trunk > > Removing the line CONFIG_LEDS_GPIO=y from > target/linux/atheros/config-3.3 and recompiling leads to booting > firmware again. > > Since this is related to kernel GPIO LED control, I posted a bug > earlier this summer about a compile problem witnessed with > kmod-leds-gpio package for ath5k, but I had no patch to offer. > Perhaps, these problems are related? > > https://dev.openwrt.org/ticket/11797 > > If not related, I do see CONFIG_LEDS_GPIO being unset in this > changeset from several years ago, with the comment specifically > referring to flash access errors. Is changeset r32885 a regression > then? > > https://dev.openwrt.org/changeset/16765/ > > On Fri, Jul 6, 2012 at 7:32 AM, Karl Palsson <ka...@tweak.net.au> wrote: > > From: Karl Palsson <ka...@remake.is> > > > > atheros trunk moved to full sysfs gpiolib, but the leds were forgotten. > > This restores the wlan led that was missing after switching from backfire > > to trunk. > > > > Signed-off-by: Karl Palsson <ka...@remake.is> > > --- > > .../linux/atheros/base-files/etc/uci-defaults/leds | 11 +++++++++++ > > target/linux/atheros/config-3.3 | 1 + > > 2 files changed, 12 insertions(+), 0 deletions(-) > > create mode 100644 target/linux/atheros/base-files/etc/uci-defaults/leds > > > > diff --git a/target/linux/atheros/base-files/etc/uci-defaults/leds > > b/target/linux/atheros/base-files/etc/uci-defaults/leds > > new file mode 100644 > > index 0000000..076a04b > > --- /dev/null > > +++ b/target/linux/atheros/base-files/etc/uci-defaults/leds > > @@ -0,0 +1,11 @@ > > +#!/bin/sh > > +# Copyright 2012 OpenWrt.org > > +# > > + > > +. /lib/functions/uci-defaults.sh > > + > > +ucidef_set_led_netdev "wlan" "wlan" "wlan" "wlan0" > > + > > +ucidef_commit_leds > > + > > +exit 0 > > diff --git a/target/linux/atheros/config-3.3 > > b/target/linux/atheros/config-3.3 > > index be0c74a..c3713b3 100644 > > --- a/target/linux/atheros/config-3.3 > > +++ b/target/linux/atheros/config-3.3 > > @@ -70,6 +70,7 @@ CONFIG_INITRAMFS_SOURCE="" > > CONFIG_IP17XX_PHY=y > > CONFIG_IRQ_CPU=y > > CONFIG_IRQ_FORCED_THREADING=y > > +CONFIG_LEDS_GPIO=y > > CONFIG_MDIO_BOARDINFO=y > > CONFIG_MIPS=y > > CONFIG_MIPS_L1_CACHE_SHIFT=5 > > -- > > 1.7.2.5 > > > > _______________________________________________ > > openwrt-devel mailing list > > openwrt-devel@lists.openwrt.org > > https://lists.openwrt.org/mailman/listinfo/openwrt-devel > > > > -- > Ben West > http://gowasabi.net > b...@gowasabi.net > _______________________________________________ > openwrt-devel mailing list > openwrt-devel@lists.openwrt.org > https://lists.openwrt.org/mailman/listinfo/openwrt-devel _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
