U-Boot 1.1.4 (Oct 22 2008 - 12:35:32)
AP94 (ar7100) U-boot 0.0.12
DRAM: b8050000: 0xc0140180
32 MB
Top of RAM usable for U-Boot at: 82000000
Reserving 4308k for U-Boot at: 81bc8000
Reserving 192k for malloc() at: 81b98000
Reserving 44 Bytes for Board Info at: 81b97fd4
Reserving 36 Bytes for Global Data at: 81b97fb0
Reserving 128k for boot params() at: 81b77fb0
Stack Pointer at: 81b77f98
Now running in RAM - U-Boot at: 81bc8000
id read 0x100000ff
flash size 8MB, sector count = 128
Flash: 8 MB
BOARD IS NOT CALIBRATED!!!
In: serial
Out: serial
Err: serial
Net: ag7100_enet_initialize...
No valid address in Flash. Using fixed address
eth0: 00:03:7f:09:0b:ad
eth0 up
No valid address in Flash. Using fixed address
eth1: 00:03:7f:09:0b:ad
eth1 up
eth0, eth1
Press CTRL+C to stop autoboot: 1 0
## Booting image at bf040000 ...
Image Name: MIPS OpenWrt Linux-2.6.37.6
Created: 2011-05-26 0:27:00 UTC
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 837467 Bytes = 817.8 kB
Load Address: 80060000
Entry Point: 80060000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 80060000) ...
## Giving linux memsize in bytes, 33554432
Starting kernel ...
Linux version 2.6.37.6 (maxim@maxdesk) (gcc version 4.5.2 (GCC) ) #1 Wed May
25 17:26:54 PDT 2011
bootconsole [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
SoC: Atheros AR7161 rev 2
Clocks: CPU:680.000MHz, DDR:340.000MHz, AHB:170.000MHz, Ref:40.000MHz
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 0x00000000 -> 0x00002000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 -> 0x00002000
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
Kernel command line: console=ttyS0,115200 board=WRT400N board=WRT400N
root=31:03 rootfstype=squashfs,jffs2 noinitrd
PID hash table entries: 128 (order: -3, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 29460k/32768k available (1947k kernel code, 3308k reserved, 369k
data, 172k init, 0k highmem)
SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS:80
Calibrating delay loop... 452.19 BogoMIPS (lpj=2260992)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
NET: Registered protocol family 16
MIPS: machine is Linksys WRT400N
registering PCI controller with io_map_base unset
bio: create slab <bio-0> at 0
pci 0000:00:11.0: invalid calibration data
pci 0000:00:12.0: invalid calibration data
pci 0000:00:11.0: BAR 0: assigned [mem 0x10000000-0x1000ffff]
pci 0000:00:11.0: BAR 0: set to [mem 0x10000000-0x1000ffff] (PCI address
[0x10000000-0x1000ffff])
pci 0000:00:12.0: BAR 0: assigned [mem 0x10010000-0x1001ffff]
pci 0000:00:12.0: BAR 0: set to [mem 0x10010000-0x1001ffff] (PCI address
[0x10010000-0x1001ffff])
PCI: mapping irq 72 to pin1@0000:00:11.0
PCI: mapping irq 73 to pin1@0000:00:12.0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c)
2001-2006 Red Hat, Inc.
msgmni has been set to 57
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
Atheros AR71xx SPI Controller driver version 0.2.4
m25p80 spi0.0: found w25x64, expected m25p80
m25p80 spi0.0: w25x64 (8192 Kbytes)
Searching for RedBoot partition table in spi0.0 at offset 0x7fe000
Searching for RedBoot partition table in spi0.0 at offset 0x7ff000
No RedBoot partition table detected in spi0.0
spi0.0: no WRT160NL signature found
Creating 9 MTD partitions on "spi0.0":
0x000000000000-0x000000030000 : "uboot"
0x000000030000-0x000000040000 : "env"
0x000000040000-0x000000180000 : "linux"
0x000000180000-0x0000007b0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
split_squashfs: no squashfs found in "spi0.0"
0x0000007b0000-0x0000007c0000 : "nvram"
0x0000007c0000-0x0000007d0000 : "factory"
0x0000007d0000-0x0000007f0000 : "language"
0x0000007f0000-0x000000800000 : "caldata"
0x000000040000-0x0000007b0000 : "firmware"
ag71xx_mdio: probed
eth0: Atheros AG71xx at 0xb9000000, irq 4
eth1: Atheros AG71xx at 0xba000000, irq 5
Atheros AR71xx hardware watchdog driver version 0.1.0
TCP westwood registered
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <gree...@candelatech.com>
All bugs added by David S. Miller <da...@redhat.com>
Node at 0x00000ea4 with length 0x00000685 would run over the end of the
erase block
Perhaps the file system was created with the wrong erase size?
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000eac:
0x1ed6 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000ec0:
0x0006 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000ec4:
0x4ddd instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000ec8:
0x4ddd instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000ecc:
0x4ddd instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000edc:
0x0800 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000ee0:
0x175d instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000ee4:
0x3063 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000ee8:
0x0020 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000eec:
0x42b1 instead
Further such events for this erase block will not be printed
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00001000:
0x73dd instead
2011/5/26 Maxim Uvarov <muva...@gmail.com>
>
>
> 2011/5/26 Jo-Philipp Wich <x...@subsignal.org>
>
>> -----BEGIN PGP SIGNED MESSAGE-----
>> Hash: SHA1
>>
>> Did you flash a jffs2 image with a wrong blocksize maybe?
>>
>>
> I tried both:
> openwrt-ar71xx-generic-root.jffs2-64k
> and
> openwrt-ar71xx-generic-root.jffs2-128k
>
> result is same.
>
> Maxim.
>
>
>> ~ Jow
>> -----BEGIN PGP SIGNATURE-----
>> Version: GnuPG v1.4.10 (GNU/Linux)
>> Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/
>>
>> iEYEARECAAYFAk3epr0ACgkQdputYINPTPPG/QCfVEJoUM+TrTNpCtDWdbSKViB/
>> 2yYAnRX/jM6J9Cm78hEz8gOETOPs+6k+
>> =JEnJ
>> -----END PGP SIGNATURE-----
>> _______________________________________________
>> openwrt-devel mailing list
>> openwrt-devel@lists.openwrt.org
>> https://lists.openwrt.org/mailman/listinfo/openwrt-devel
>>
>
>
>
> --
> Best regards,
> Maxim Uvarov
>
--
Best regards,
Maxim Uvarov
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
