Hi All, I have one of these hanging around and not used for much. Happy to assist with testing, if I could get some instructions as to how the image is to be compiled (basic make menuconfig settings). Also on the photo here I can see TX and Rx only. I cannot see GND marked out. Any hints?
Thannks Hanno On 9 May 2011 06:31, John Crispin <j...@phrozen.org> wrote: > On 08/05/11 20:16, Andrej Vlašić wrote: > >>>> Also this board doesn't have wlan eeprom, instead it is read by a wlan > >> driver from a file inside fw. If someone has some answers on how to > modify > >> current ath5k driver, would like to know. > >> > >>> in a file inside the FS or in a sector on the flash ? > >> > > > > Inside a file, which has wlan mac address in it, and it has that atheros > > AR5001-0000-0000 Reference Card thing inside. > > > > About that usb gpio. I already tried 29 and some others to > xway_register_dwc > > but it stays the same Disconnected port , and no power on it. Do I also > need > > to set lq_pci_data.gpio and lq_pci_data.irq? ( currently I just copied > > everything from easy50712 mach config and changed partitions and other > stuff > > for my board) > > > > Thanx > > > > pci is only needed for wifi to work. > > > > > > > > > > > _______________________________________________ > > openwrt-devel mailing list > > openwrt-devel@lists.openwrt.org > > https://lists.openwrt.org/mailman/listinfo/openwrt-devel > > _______________________________________________ > openwrt-devel mailing list > openwrt-devel@lists.openwrt.org > https://lists.openwrt.org/mailman/listinfo/openwrt-devel >
_______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
