I understand your points and that is taken care of, but how exactly is
Openstack going to connect to the hardware if the hardware has no OS and no IP?
How should the hardware be prepared so I can give Openstack the information it
needs to enroll the hardware?
Thanks,
Jake
________________________________
From: "K, Shanthakumar" <shanthakuma...@hp.com>
To: Jake G. <dj_dark_jungl...@yahoo.com>
Cc: "openstack@lists.openstack.org" <openstack@lists.openstack.org>
Sent: Friday, August 23, 2013 3:08 PM
Subject: RE: [Openstack] Baremetal - Hardware preparation
Hi Jake,
Your physical hardware should be maximum enough to support your OS
configurations and baremetal flavor you have created.
Ex:
1. Your physical hardware should contain minimum configurations to run an
operating system
2. You need to take care of your Baremetal Flavor created WRT to your
available hardware.
Thanks
Shanthakumar K
From:Jake G. [mailto:dj_dark_jungl...@yahoo.com]
Sent: Friday, August 23, 2013 10:07 AM
To: openstack@lists.openstack.org
Subject: [Openstack] Baremetal - Hardware preparation
Hi all,
I have been following this doc
https://wiki.openstack.org/wiki/Baremetal#Image_Requirements
to setup openstack for baremetal provisioning. I have configured oopenstack
properly, created an image,
and now I am ready to enroll my physical hardware. However, there seems to be
no mention of how to
prepare my physical hardware.
Does anyone know what is required and what is the process to prepare my
hardware?
Thank you for your help,
Jake
_______________________________________________
Mailing list: http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
Post to : openstack@lists.openstack.org
Unsubscribe : http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
