On Fri, May 06, 2011 at 08:59:37PM +0200, Luka Perkov wrote:
> as the subject implies I have never used jtag. I would like to replace
> original uboot from this device:
>
> http://wiki.openwrt.org/toh/gigaset/sx76x
Have you already tried connecting a serial cable? If there's still a
working u-boot on the device, it would be easier to use that to
flash a new one.
> 1. I think that is the cable is interface/parport.cfg . Am I correct? If
> not how my interface config file should look like?
That's correct. I use the same interface (but for an ARM target).
If you're using a Linux host, you just want:
interface parport
parport_cable wiggler
in your config. Make sure you have the "ppdev" kernel module loaded so that
/dev/parport0 shows up.
--
Eric Cooper e c c @ c m u . e d u
_______________________________________________
Openocd-development mailing list
Openocd-development@lists.berlios.de
https://lists.berlios.de/mailman/listinfo/openocd-development
