On 14:26 Tue 03 May , Øyvind Harboe wrote:
> Please be more specific. We intend to move forward on this one and
> we are interested in hearing what problems you are seeing.
>
> This is an important and somewhat tricky problem that we intend
> to put to bet once and for all, and knew that there were risks of
> regressions before we would get it right.
>
# ./build/src/openocd -c "interface jlink" -c "jlink pid 0x102" -f
board/at91rm9200-ek.cfg -s tcl
Open On-Chip Debugger 0.5.0-dev-00871-g2a28ce8-dirty (2011-05-03-20:04)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.berlios.de/doc/doxygen/bugs.html
Warn : Adapter driver 'jlink' did not declare which transports it allows;
assuming legacy JTAG-only
Info : only one transport option; autoselect 'jtag'
dcc downloads are enabled
trst_and_srst separate srst_gates_jtag trst_push_pull srst_open_drain
at91rm9200_ek_init
Info : J-Link initialization started / target CPU reset initiated
Info : J-Link compiled Jul 30 2008 11:24:37 ARM Rev.5
Info : J-Link caps 0x80d7bbf
Info : J-Link hw version 52000
Info : J-Link hw type J-Link
Info : J-Link max mem block 9992
Info : J-Link configuration
Info : USB-Address: 0x1
Info : Kickstart power on JTAG-pin 19: 0xffffffff
Info : Vref = 3.261 TCK = 1 TDI = 0 TDO = 1 TMS = 0 SRST = 0 TRST = 0
Info : J-Link JTAG Interface ready
Error: An adapter speed is not selected in the init script. Insert a call to
adapter_khz or jtag_rclk to proceed.
in procedure 'init'
Best Regards,
J.
_______________________________________________
Openocd-development mailing list
Openocd-development@lists.berlios.de
https://lists.berlios.de/mailman/listinfo/openocd-development
