Hi, On 2010.01.14 15:52, Øyvind Harboe wrote: > I'm trying to get a sense for what cables are used out there. > > What would you guys expect to get with a JTAG debugger? > > The most common seems to be the JTAG 20 cable. > > I've seen JTAG 14 on an older AT91EB40a. > > Ultimately I would expect to users to solder their own custom JTAG > cable for smaller footprint application PCBs... I've seen this a lot. > > Flying leads sounds nice, but it wouldn't have replaced hand soldered > solutions where I've seen them. > > I've seen JTAG 20 used with SWD. Is there a smaller SWD connector? > >
The JTAG/SWD cable with small 10 pin 1.27mm pitch connector like the one on MCB1700 board: http://www.keil.com/support/man/docs/mcb1700/mcb1700_to_jtag.htm would be great to get. The Code Red board RBC1768 I previously had also had such connector with equivalent pinout (except for pin 7, which is populated here), which makes me think about some existing standard: http://support.code-red-tech.com/CodeRedWiki/RDB1768Support Regards, Audrius Urmanavicius _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
