Duane Ellis pisze: > That which comes from legitimate engineering evaluation and examination, > I believe is perfectly fine. > ie: If I have it in my hand,and I can reasonably draw a schematic by > physical examination of the PCB ...
and that is exactly what i did - removed two screws, took out the pcb and drew a sch out of what i saw. it was pretty easy, as the pcb has two layers and all the components are on the top side. you cannot do the RLink out of that sch, because some minor stuff can be wrong (RLink is much more than just an ARM JTAG) - i didn't pay extreme attention to stuff that is useless for ARMs. You would still need the firmware for the ST7 to do that (; if that is questionable, i suppose that i can just use words to describe that - where the JTAG lines are connected, but that would be pretty much the same as posting the sch [; to be honest, the RLink protocol is pretty much the effect of rev. engineering and intercepting the USB transmissions, and RLink is supported based on that info. now it could be supported fully, not just the Primer. 4\/3!! _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
