lou.openocd...@fixit.nospammail.net wrote: > On Fri, Mar 06, 2009 at 12:36:52PM +0100, freddie_cho...@op.pl wrote: >> I'm using openocd-0.1.0 for Windows >> >> I got the STM32F10X-128k-EVAL board with the original RLink. I can debug the >> primer1, which has the Rlink embedded. I connect to the current board with >> the same command >> >> openocd -f interface/rlink.cfg -f board/stm32f10x_128k_eval.cfg > > [...] > >> the problem is, that the target is held in reset no matter what I do. > > > Uh-oh. The rlink driver was created based on the schematic for the > Primer1, which contains an Rlink chip. The standalone Rlink device has > circuitry that the Primer does not. I made the best guesses I could, > based on USB traffic traces, to accomodate the additional unknown > hardware. >
Ok, I'll look into it. I've got an Olimex STM32-P103 (STM32F103RBT6) to use it with now, so that should be close enough. Will report back ASAP. _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
