On 09/28/2012 01:06 PM, Rainer Heilke wrote: > Greetings. > > I've connected a Seagate 3000GB HDD to my OpenIndiana oi_151.1.6 X86 > server. But when I try to use it, only 746GB show. Printing the > partition table from format shows: > partition> pri > Current partition table (original): > Total disk cylinders available: 48722 + 2 (reserved cylinders) > > Part Tag Flag Cylinders Size Blocks > 0 unassigned wm 0 0 (0/0/0) 0 > 1 unassigned wm 0 0 (0/0/0) 0 > 2 backup wu 0 - 48721 746.46GB (48722/0/0) 1565437860 > 3 unassigned wm 0 0 (0/0/0) 0 > 4 unassigned wm 0 0 (0/0/0) 0 > 5 unassigned wm 0 0 (0/0/0) 0 > 6 unassigned wm 0 0 (0/0/0) 0 > 7 unassigned wm 0 0 (0/0/0) 0 > 8 boot wu 0 - 0 15.69MB (1/0/0) 32130 > 9 unassigned wm 0 0 (0/0/0) 0 > > format> inq > Vendor: ST3000DM > Product: 001-9YN166 > Revision: > > Total disk size is 48725 cylinders > Cylinder size is 32130 (512 byte) blocks > > Cylinders > Partition Status Type Start End Length % > ========= ====== ============ ===== === ====== === > 1 Active Solaris 1 48724 48724 100 > > > So, how can I get ZFS to see the full 3TB?
Are you trying to use this driver for rpool? If not, you can simply tell ZFS to use the entire drive, which should bypass any potential partitioning issues. Cheers, -- Saso _______________________________________________ OpenIndiana-discuss mailing list [email protected] http://openindiana.org/mailman/listinfo/openindiana-discuss
