Hi Sergio, Could you try to run your application without flowvisor. I find it strange that flowvisor would be causing a problem here, even though it treats lldp packets rather awkwardly.
That said, if your setup works without flowvisor then we can definitely say that flowvisor is at fault and we can investigate further. -- Ali Al-Shabibi On 12 janv. 2012, at 04:24, Sergio Jiménez Feijóo <jjji...@gmail.com> wrote: > Hi guys, > > I've developed a NOX aplication which needs to use the topology component to > discover the network topology. I've tested my application in a testbed of 6 > Linksys WRT54GL running the OpenWRT Pantou firmware (without flowvisor) and > it worked like a charm. Now I'm testing my aplication in a testbed of 5 NEC > IP8800/S3640-24T2XW (with flowvisor) and the topology detection isn't working > at all (the data struct is empty). > > Since OpenFlow allows an application to run in different devices I've > discarded the fact of using new switches as the cause of the error. Therefore > I think flowvisor is causing the topology component not to run properly. Is > this possible? Have you experienced any problems with flowvisor and NOX? > > Thank you. > > http://homestore.cisco.eu/store/ciscoeu/en_IE/pd/productID.241269400 > http://www.openflow.org/wk/index.php/Pantou_:_OpenFlow_1.0_for_OpenWRT > http://yuba.stanford.edu/foswiki/bin/view/OpenFlow/Deployment/Vendor/NEC > > _______________________________________________ > nox-dev mailing list > nox-dev@noxrepo.org > http://noxrepo.org/mailman/listinfo/nox-dev _______________________________________________ nox-dev mailing list nox-dev@noxrepo.org http://noxrepo.org/mailman/listinfo/nox-dev
