Hi kk, can you tell me how to view the nox logs...where its being placed ...
thanks Regards Hasnat On Sat, Dec 4, 2010 at 11:22 PM, kk yap <yap...@stanford.edu> wrote: > Hi Hasnat, > > You are not telling me much other than you have some errors going on. > It would definitely help if you can tell me what the errors are. Then > maybe I can see if I can advise on how to get rid of them. So, can I > have the logs? Thanks. > > Regards > KK > > PS>> Unless this is meant to be a private email, please don't drop the > mailing list. Thanks. > > On 4 December 2010 06:39, Hasnat Ahmed <10msithah...@seecs.edu.pk> wrote: > > now i have redone all the steps mentioned in "CREATE AN OPENFLOW NETWORK > > WITHIN A SINGLE PC" my switch portion is verified successfully and > drawing > > command is also working fine but this time at controller(NOX) portion > when i > > run the ./nox_core -i ptcp:6633 routing command > > it is displaying me that line "openflow compiled" and cursor stays blink > > like its in blocking stage etc i dont know > > > > than when i run a command vms-start.py 2hosts-2ofsw.vms.xml > > its shows me error "hda.disk " file is missing. but i have placed this > file > > and its present. > > > > On Wed, Dec 1, 2010 at 6:18 PM, kk yap <yap...@stanford.edu> wrote: > >> > >> I see the errors on the switch side, but what about the NOX side? > >> What is the controller saying about the switch? Is the switch > >> disconnecting or is the controller disconnecting the switch? That's > >> critical for understanding what is happening. > >> > >> Regards > >> KK > >> > >> On 1 December 2010 03:22, Hasnat Ahmed <10msithah...@seecs.edu.pk> > wrote: > >> > sorry yapkke , i did not get ur point. > >> > > >> > On Wed, Dec 1, 2010 at 11:57 AM, kk yap <yap...@stanford.edu> wrote: > >> >> > >> >> What about the log from the NOX side of things? > >> >> > >> >> Regards > >> >> KK > >> >> > >> >> On 30 November 2010 22:49, Hasnat Ahmed <10msithah...@seecs.edu.pk> > >> >> wrote: > >> >> > Hi , while creating a openflow network within a single pc I have > >> >> > verified > >> >> > successfully switch set up part but when tried to setup the > >> >> > controller > >> >> > portion. we are examing a issue. controller port (6663) is in > >> >> > listening > >> >> > mode > >> >> > (fine)but when we start the controller it will 1st show its status > >> >> > connected > >> >> > and then lose the connection and cannot reestablish the connection. > >> >> > so > >> >> > without holding the conntroller connectivity the simulation cant > run. > >> >> > > >> >> > kindly see the attached pic. > >> >> > > >> >> > we are not getting out that why controller loses its connectivity. > >> >> > > >> >> > > >> >> > > >> >> > > >> >> > > >> >> > > >> >> > _______________________________________________ > >> >> > nox-dev mailing list > >> >> > nox-dev@noxrepo.org > >> >> > http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org > >> >> > > >> >> > > >> > > >> > > > > > >
_______________________________________________ nox-dev mailing list nox-dev@noxrepo.org http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org
