From: Giuseppe Cavallaro <peppe.cavall...@st.com>
This patch avoids to call the stmmac_adjust_link when
the driver is connected to a switch by using the FIXED_PHY
support. Prior this patch the phydev->irq was set as PHY_POLL
so periodically the phy handler was invoked spending useless
time because the link cannot actually change.
Note that the stmmac_adjust_link will be called just one
time and this guarantees that the ST glue logic will be
setup according to the mode and speed fixed.
Signed-off-by: Giuseppe Cavallaro <peppe.cavall...@st.com>
Signed-off-by: Alexandre TORGUE <alexandre.tor...@st.com>
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 90b2612..eab7ac0 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -866,6 +866,11 @@ static int stmmac_init_phy(struct net_device *dev)
phy_disconnect(phydev);
return -ENODEV;
}
+
+ /* If attached to a switch, there is no reason to poll phy handler */
+ if (!strcmp(priv->plat->phy_bus_name, "fixed"))
+ phydev->irq = PHY_IGNORE_INTERRUPT;
+
pr_debug("stmmac_init_phy: %s: attached to PHY (UID 0x%x)"
" Link = %d\n", dev->name, phydev->phy_id, phydev->link);
--
1.9.1
