[PATCH v1 2/2] sfp: add support for 100 base-x SFPs

[Bjarni Jonasson]

Add support for 100Base-FX, 100Base-LX, 100Base-PX and 100Base-BX10 modules
This is needed for Sparx-5 switch.

Signed-off-by: Bjarni Jonasson <bjarni.jonas...@microchip.com>
---
 drivers/net/phy/sfp-bus.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/net/phy/sfp-bus.c b/drivers/net/phy/sfp-bus.c
index 58014feedf6c..b2a9ee3dd28e 100644
--- a/drivers/net/phy/sfp-bus.c
+++ b/drivers/net/phy/sfp-bus.c
@@ -265,6 +265,12 @@ void sfp_parse_support(struct sfp_bus *bus, const struct 
sfp_eeprom_id *id,
            br_min <= 1300 && br_max >= 1200)
                phylink_set(modes, 1000baseX_Full);
 
+       /* 100Base-FX, 100Base-LX, 100Base-PX, 100Base-BX10 */
+       if (id->base.e100_base_fx || id->base.e100_base_lx)
+               phylink_set(modes, 100baseFX_Full);
+       if ((id->base.e_base_px || id->base.e_base_bx10) && br_nom == 100)
+               phylink_set(modes, 100baseFX_Full);
+
        /* For active or passive cables, select the link modes
         * based on the bit rates and the cable compliance bytes.
         */
@@ -385,6 +391,9 @@ phy_interface_t sfp_select_interface(struct sfp_bus *bus,
        if (phylink_test(link_modes, 1000baseX_Full))
                return PHY_INTERFACE_MODE_1000BASEX;
 
+       if (phylink_test(link_modes, 100baseFX_Full))
+               return PHY_INTERFACE_MODE_100BASEX;
+
        dev_warn(bus->sfp_dev, "Unable to ascertain link mode\n");
 
        return PHY_INTERFACE_MODE_NA;
-- 
2.17.1