On Tue, 15 Dec 2020 14:47:10 +0100
Lorenzo Bianconi <lorenzo.bianc...@redhat.com> wrote:
> [...]
> > > xdp_act = bpf_prog_run_xdp(xdp_prog, &xdp);
> > > diff --git a/drivers/net/ethernet/intel/i40e/i40e_txrx.c
> > > b/drivers/net/ethernet/intel/i40e/i40e_txrx.c
> > > index 4dbbbd49c389..fcd1ca3343fb 100644
> > > --- a/drivers/net/ethernet/intel/i40e/i40e_txrx.c
> > > +++ b/drivers/net/ethernet/intel/i40e/i40e_txrx.c
> > > @@ -2393,12 +2393,12 @@ static int i40e_clean_rx_irq(struct i40e_ring
> > > *rx_ring, int budget)
> > >
> > > /* retrieve a buffer from the ring */
> > > if (!skb) {
> > > - xdp.data = page_address(rx_buffer->page) +
> > > - rx_buffer->page_offset;
> > > - xdp.data_meta = xdp.data;
> > > - xdp.data_hard_start = xdp.data -
> > > - i40e_rx_offset(rx_ring);
> > > - xdp.data_end = xdp.data + size;
> > > + unsigned int offset = i40e_rx_offset(rx_ring);
> >
> > I now see that we could call the i40e_rx_offset() once per napi, so can
> > you pull this variable out and have it initialized a single time? Applies
> > to other intel drivers as well.
>
> ack, fine. I will fix in v4.
Be careful with the Intel drivers. They have two modes (at compile
time) depending on PAGE_SIZE in system. In one of the modes (default
one) you can place init of xdp.frame_sz outside the NAPI loop and init a
single time. In the other mode you cannot, and it becomes dynamic per
packet. Intel review this carefully, please!
--
Best regards,
Jesper Dangaard Brouer
MSc.CS, Principal Kernel Engineer at Red Hat
LinkedIn: http://www.linkedin.com/in/brouer
