> -----Original Message----- > From: Marc Kleine-Budde <m...@pengutronix.de> > Sent: 2020年9月25日 15:33 > To: Joakim Zhang <qiangqing.zh...@nxp.com>; linux-...@vger.kernel.org > Cc: dl-linux-imx <linux-...@nxp.com>; netdev@vger.kernel.org > Subject: Re: [PATCH linux-can-next/flexcan 1/4] can: flexcan: initialize all > flexcan > memory for ECC function > > On 9/25/20 5:10 PM, Joakim Zhang wrote: > > There is a NOTE at the section "Detection and correction of memory errors": > > All FlexCAN memory must be initialized before starting its operation > > in order to have the parity bits in memory properly updated. > > CTRL2[WRMFRZ] grants write access to all memory positions that require > > initialization, ranging from 0x080 to 0xADF and from 0xF28 to 0xFFF > > when the CAN FD feature is enabled. The RXMGMASK, RX14MASK, > RX15MASK, > > and RXFGMASK registers need to be initialized as well. MCR[RFEN] must not > be set during memory initialization. > > > > Memory range from 0x080 to 0xADF, there are reserved memory > > (unimplemented by hardware), these memory can be initialized or not. > > > > Initialize all FlexCAN memory before accessing them, otherwise, memory > > errors may be detected. The internal region cannot be initialized when > > the hardware does not support ECC. > > > > Signed-off-by: Joakim Zhang <qiangqing.zh...@nxp.com> > > Is this whole patch valid/compatible with the mx7,too?
Hi Marc, I notice it just now, seems lack of patch for imx firmware in upstream, that will always export scu symbols. include/linux/firmware/imx/svc/misc.h Best Regards, Joakim Zhang > Marc > > -- > Pengutronix e.K. | Marc Kleine-Budde | > Embedded Linux | https://www.pengutronix.de | > Vertretung West/Dortmund | Phone: +49-231-2826-924 | > Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
