When doing "ip link set dev ... up" for a ksz9477 backed link, ksz9477_phy_setup is called and it calls phy_remove_link_mode to remove 1000baseT HDX. During phy_remove_link_mode, phy_advertise_supported is called. Doing so reverts any previous change to advertised link modes e.g. using a udevd .link file.
phy_remove_link_mode is not meant to be used while opening a link and should be called during phy probe when the link is not yet available to userspace. Therefore move the phy_remove_link_mode calls into ksz9477_setup. This is called during dsa_switch_register and thus comes after ksz9477_switch_detect, which initializes dev->features. Remove phy_setup from ksz_dev_ops as no users remain. Link: https://lore.kernel.org/netdev/20200715192722.gd1256...@lunn.ch/ Fixes: 42fc6a4c613019 ("net: dsa: microchip: prepare PHY for proper advertisement") Signed-off-by: Helmut Grohne <helmut.gro...@intenta.de> --- drivers/net/dsa/microchip/ksz9477.c | 31 ++++++++++---------------- drivers/net/dsa/microchip/ksz_common.c | 2 -- drivers/net/dsa/microchip/ksz_common.h | 2 -- 3 files changed, 12 insertions(+), 23 deletions(-) changes since v1: * Don't change phy_remove_link_mode. Instead, call it at the right time. Thanks to Andrew Lunn for the detailed explanation. Helmut diff --git a/drivers/net/dsa/microchip/ksz9477.c b/drivers/net/dsa/microchip/ksz9477.c index 8d15c3016024..d0023916e1e8 100644 --- a/drivers/net/dsa/microchip/ksz9477.c +++ b/drivers/net/dsa/microchip/ksz9477.c @@ -974,23 +974,6 @@ static void ksz9477_port_mirror_del(struct dsa_switch *ds, int port, PORT_MIRROR_SNIFFER, false); } -static void ksz9477_phy_setup(struct ksz_device *dev, int port, - struct phy_device *phy) -{ - /* Only apply to port with PHY. */ - if (port >= dev->phy_port_cnt) - return; - - /* The MAC actually cannot run in 1000 half-duplex mode. */ - phy_remove_link_mode(phy, - ETHTOOL_LINK_MODE_1000baseT_Half_BIT); - - /* PHY does not support gigabit. */ - if (!(dev->features & GBIT_SUPPORT)) - phy_remove_link_mode(phy, - ETHTOOL_LINK_MODE_1000baseT_Full_BIT); -} - static bool ksz9477_get_gbit(struct ksz_device *dev, u8 data) { bool gbit; @@ -1353,7 +1336,7 @@ static void ksz9477_config_cpu_port(struct dsa_switch *ds) static int ksz9477_setup(struct dsa_switch *ds) { struct ksz_device *dev = ds->priv; - int ret = 0; + int ret = 0, i; dev->vlan_cache = devm_kcalloc(dev->dev, sizeof(struct vlan_table), dev->num_vlans, GFP_KERNEL); @@ -1391,6 +1374,17 @@ static int ksz9477_setup(struct dsa_switch *ds) ksz_init_mib_timer(dev); + for (i = 0; i < dev->phy_port_cnt; ++i) { + /* The MAC actually cannot run in 1000 half-duplex mode. */ + phy_remove_link_mode(&dev->ports[i].phydev, + ETHTOOL_LINK_MODE_1000baseT_Half_BIT); + + /* PHY does not support gigabit. */ + if (!(dev->features & GBIT_SUPPORT)) + phy_remove_link_mode(&dev->ports[i].phydev, + ETHTOOL_LINK_MODE_1000baseT_Full_BIT); + } + return 0; } @@ -1603,7 +1597,6 @@ static const struct ksz_dev_ops ksz9477_dev_ops = { .get_port_addr = ksz9477_get_port_addr, .cfg_port_member = ksz9477_cfg_port_member, .flush_dyn_mac_table = ksz9477_flush_dyn_mac_table, - .phy_setup = ksz9477_phy_setup, .port_setup = ksz9477_port_setup, .r_mib_cnt = ksz9477_r_mib_cnt, .r_mib_pkt = ksz9477_r_mib_pkt, diff --git a/drivers/net/dsa/microchip/ksz_common.c b/drivers/net/dsa/microchip/ksz_common.c index fd1d6676ae4f..7b6c0dce7536 100644 --- a/drivers/net/dsa/microchip/ksz_common.c +++ b/drivers/net/dsa/microchip/ksz_common.c @@ -358,8 +358,6 @@ int ksz_enable_port(struct dsa_switch *ds, int port, struct phy_device *phy) /* setup slave port */ dev->dev_ops->port_setup(dev, port, false); - if (dev->dev_ops->phy_setup) - dev->dev_ops->phy_setup(dev, port, phy); /* port_stp_state_set() will be called after to enable the port so * there is no need to do anything. diff --git a/drivers/net/dsa/microchip/ksz_common.h b/drivers/net/dsa/microchip/ksz_common.h index f2c9bb68fd33..7d11dd32ec0d 100644 --- a/drivers/net/dsa/microchip/ksz_common.h +++ b/drivers/net/dsa/microchip/ksz_common.h @@ -119,8 +119,6 @@ struct ksz_dev_ops { u32 (*get_port_addr)(int port, int offset); void (*cfg_port_member)(struct ksz_device *dev, int port, u8 member); void (*flush_dyn_mac_table)(struct ksz_device *dev, int port); - void (*phy_setup)(struct ksz_device *dev, int port, - struct phy_device *phy); void (*port_cleanup)(struct ksz_device *dev, int port); void (*port_setup)(struct ksz_device *dev, int port, bool cpu_port); void (*r_phy)(struct ksz_device *dev, u16 phy, u16 reg, u16 *val); -- 2.20.1
