On 2/14/19 2:40 PM, Andrew Lunn wrote:
> On Thu, Feb 14, 2019 at 07:45:57AM +0100, Christophe Roullier wrote:
>> @@ -131,19 +185,19 @@ static int stm32mp1_set_mode(struct
>> plat_stmmacenet_data *plat_dat)
>> case PHY_INTERFACE_MODE_RGMII:
>> val = SYSCFG_PMCR_ETH_SEL_RGMII;
>> - if (dwmac->int_phyclk)
>> + if (dwmac->eth_clk_sel_reg)
>> val |= SYSCFG_PMCR_ETH_CLK_SEL;
>> pr_debug("SYSCFG init : PHY_INTERFACE_MODE_RGMII\n");
>> break;
>
> Hi Christophe
>
> This code should handle all 4 PHY_INTERFACE_MODE_RGMII* values.
>
> Andrew
>
ReReHi Andrew,
Sorry, I've misunderstood your question ;-)
And you spoke about :
case PHY_INTERFACE_MODE_RGMII:
case PHY_INTERFACE_MODE_RGMII_ID:
case PHY_INTERFACE_MODE_RGMII_RXID:
case PHY_INTERFACE_MODE_RGMII_TXID:
So in my setup I've only RGMII interface, so I've never tested 3 others
interfaces (_ID, _RXID, _TXID).
So do I need to add cases in my driver ?
Thanks
Christophe
