On Wed, Jan 16, 2019 at 06:37:50PM +0000, Fabrizio Castro wrote:
> From: Biju Das <biju....@bp.renesas.com>
>
> This patch adds ethernet support to the sub board.
>
> Signed-off-by: Biju Das <biju....@bp.renesas.com>
> Signed-off-by: Fabrizio Castro <fabrizio.cas...@bp.renesas.com>
> Reviewed-by: Chris Paterson <chris.paters...@renesas.com>
> ---
> arch/arm64/boot/dts/renesas/cat875.dtsi | 30 ++++++++++++++++++++++++++++++
> 1 file changed, 30 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/renesas/cat875.dtsi
> b/arch/arm64/boot/dts/renesas/cat875.dtsi
> index a41d0d8..805ffa7 100644
> --- a/arch/arm64/boot/dts/renesas/cat875.dtsi
> +++ b/arch/arm64/boot/dts/renesas/cat875.dtsi
> @@ -7,4 +7,34 @@
>
> / {
> model = "Silicon Linux sub board for CAT874 (CAT875)";
> +
> + aliases {
> + ethernet0 = &avb;
> + };
> +};
> +
> +&avb {
> + pinctrl-0 = <&avb_pins>;
> + pinctrl-names = "default";
> + renesas,no-ether-link;
Is the renesas,no-ether-link required?
My understanding is that "the property should only be used when a
board does not provide a proper AVB_LINK signal". And from my reading
of the schematic it looks like that signal may be provided on this board.
That said, I have an outstanding patch for this for E3/Ebisu which
I have not applied because I am unsure of its correctness.
[PATCH] arm64: dts: renesas: ebisu: Remove renesas, no-ether-link property
https://patchwork.kernel.org/patch/10692755/
Similar patches have been applied for other boards.
f.e:
[PATCH] arm64: dts: renesas: salvator-x: Remove renesas, no-ether-link property
https://git.kernel.org/torvalds/c/87c059e9c39d
> + phy-handle = <&phy0>;
> + phy-mode = "rgmii";
> + status = "okay";
> +
> + phy0: ethernet-phy@0 {
> + rxc-skew-ps = <1500>;
> + reg = <0>;
> + interrupt-parent = <&gpio2>;
> + interrupts = <21 IRQ_TYPE_LEVEL_LOW>;
> + reset-gpios = <&gpio1 20 GPIO_ACTIVE_LOW>;
> + };
> +};
> +
> +&pfc {
> + avb_pins: avb {
> + mux {
> + groups = "avb_mii";
> + function = "avb";
> + };
> + };
> };
> --
> 2.7.4
>
