On 3/27/2018 10:47 PM, Florian Fainelli wrote:
There were a number of issues with setting the RX coalescing parameters:
- we would not be preserving values that would have been configured
across close/open calls, instead we would always reset to no timeout
and 1 interrupt per packet, this would also prevent DIM from setting its
default usec/pkts values
- when adaptive RX would be turned on, we woud not be fetching the
default parameters, we would stay with no timeout/1 packet per interrupt
until the estimator kicks in and changes that
- finally disabling adaptive RX coalescing while providing parameters
would not be honored, and we would stay with whatever DIM had previously
determined instead of the user requested parameters
Fixes: 9f4ca05827a2 ("net: bcmgenet: Add support for adaptive RX coalescing")
Signed-off-by: Florian Fainelli <f.faine...@gmail.com>
---
drivers/net/ethernet/broadcom/genet/bcmgenet.c | 78 ++++++++++++++++++--------
drivers/net/ethernet/broadcom/genet/bcmgenet.h | 4 +-
2 files changed, 57 insertions(+), 25 deletions(-)
diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.c
b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
index 7db8edc643ec..76409debb796 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
@@ -625,18 +625,18 @@ static int bcmgenet_get_coalesce(struct net_device *dev,
return 0;
}
-static void bcmgenet_set_rx_coalesce(struct bcmgenet_rx_ring *ring)
+static void bcmgenet_set_rx_coalesce(struct bcmgenet_rx_ring *ring,
+ u32 usecs, u32 pkts)
{
struct bcmgenet_priv *priv = ring->priv;
unsigned int i = ring->index;
u32 reg;
- bcmgenet_rdma_ring_writel(priv, i, ring->dim.coal_pkts,
- DMA_MBUF_DONE_THRESH);
+ bcmgenet_rdma_ring_writel(priv, i, pkts, DMA_MBUF_DONE_THRESH);
reg = bcmgenet_rdma_readl(priv, DMA_RING0_TIMEOUT + i);
reg &= ~DMA_TIMEOUT_MASK;
- reg |= DIV_ROUND_UP(ring->dim.coal_usecs * 1000, 8192);
+ reg |= DIV_ROUND_UP(usecs * 1000, 8192);
bcmgenet_rdma_writel(priv, reg, DMA_RING0_TIMEOUT + i);
}
@@ -645,6 +645,8 @@ static int bcmgenet_set_coalesce(struct net_device *dev,
{
struct bcmgenet_priv *priv = netdev_priv(dev);
struct bcmgenet_rx_ring *ring;
+ struct net_dim_cq_moder moder;
+ u32 usecs, pkts;
unsigned int i;
/* Base system clock is 125Mhz, DMA timeout is this reference clock
@@ -682,25 +684,37 @@ static int bcmgenet_set_coalesce(struct net_device *dev,
for (i = 0; i < priv->hw_params->rx_queues; i++) {
ring = &priv->rx_rings[i];
- ring->dim.coal_usecs = ec->rx_coalesce_usecs;
- ring->dim.coal_pkts = ec->rx_max_coalesced_frames;
- if (!ec->use_adaptive_rx_coalesce && ring->dim.use_dim) {
- ring->dim.coal_pkts = 1;
- ring->dim.coal_usecs = 0;
+
+ ring->rx_coalesce_usecs = ec->rx_coalesce_usecs;
+ ring->rx_max_coalesced_frames = ec->rx_max_coalesced_frames;
+ usecs = ring->rx_coalesce_usecs;
+ pkts = ring->rx_max_coalesced_frames;
+
+ if (ec->use_adaptive_rx_coalesce) {
+ moder = net_dim_get_def_profile(ring->dim.dim.mode);
+ usecs = moder.usec;
+ pkts = moder.pkts;
}
What if DIM is already in use? We don't want to set default values if
DIM is already working.
+
ring->dim.use_dim = ec->use_adaptive_rx_coalesce;
- bcmgenet_set_rx_coalesce(ring);
+ bcmgenet_set_rx_coalesce(ring, usecs, pkts);
}
ring = &priv->rx_rings[DESC_INDEX];
- ring->dim.coal_usecs = ec->rx_coalesce_usecs;
- ring->dim.coal_pkts = ec->rx_max_coalesced_frames;
- if (!ec->use_adaptive_rx_coalesce && ring->dim.use_dim) {
- ring->dim.coal_pkts = 1;
- ring->dim.coal_usecs = 0;
+
+ ring->rx_coalesce_usecs = ec->rx_coalesce_usecs;
+ ring->rx_max_coalesced_frames = ec->rx_max_coalesced_frames;
+ usecs = ring->rx_coalesce_usecs;
+ pkts = ring->rx_max_coalesced_frames;
+
+ if (ec->use_adaptive_rx_coalesce) {
+ moder = net_dim_get_def_profile(ring->dim.dim.mode);
+ usecs = moder.usec;
+ pkts = moder.pkts;
}
Same as above.
+
ring->dim.use_dim = ec->use_adaptive_rx_coalesce;
- bcmgenet_set_rx_coalesce(ring);
+ bcmgenet_set_rx_coalesce(ring, usecs, pkts);
return 0;
}
@@ -1924,10 +1938,7 @@ static void bcmgenet_dim_work(struct work_struct *work)
struct net_dim_cq_moder cur_profile =
net_dim_get_profile(dim->mode, dim->profile_ix);
- ring->dim.coal_usecs = cur_profile.usec;
- ring->dim.coal_pkts = cur_profile.pkts;
-
- bcmgenet_set_rx_coalesce(ring);
+ bcmgenet_set_rx_coalesce(ring, cur_profile.usec, cur_profile.pkts);
dim->state = NET_DIM_START_MEASURE;
}
@@ -2079,14 +2090,30 @@ static void init_umac(struct bcmgenet_priv *priv)
dev_dbg(kdev, "done init umac\n");
}
-static void bcmgenet_init_dim(struct bcmgenet_net_dim *dim,
+static void bcmgenet_init_dim(struct bcmgenet_rx_ring *ring,
void (*cb)(struct work_struct *work))
{
+ struct bcmgenet_net_dim *dim = &ring->dim;
+ struct net_dim_cq_moder moder;
+ u32 usecs, pkts;
+
INIT_WORK(&dim->dim.work, cb);
dim->dim.mode = NET_DIM_CQ_PERIOD_MODE_START_FROM_EQE;
dim->event_ctr = 0;
dim->packets = 0;
dim->bytes = 0;
I would expect only dim related code in a function called init_dim(). I
think the code below should be elsewhere. Or maybe change the function
name to init_rx_coalesce().
+
+ usecs = ring->rx_coalesce_usecs;
+ pkts = ring->rx_max_coalesced_frames;
+
+ /* If DIM was enabled, re-apply default parameters */
+ if (dim->use_dim) {
+ moder = net_dim_get_def_profile(dim->dim.mode);
+ usecs = moder.usec;
+ pkts = moder.pkts;
+ }
+
+ bcmgenet_set_rx_coalesce(ring, usecs, pkts);
}
/* Initialize a Tx ring along with corresponding hardware registers */
@@ -2178,7 +2205,7 @@ static int bcmgenet_init_rx_ring(struct bcmgenet_priv
*priv,
if (ret)
return ret;
- bcmgenet_init_dim(&ring->dim, bcmgenet_dim_work);
+ bcmgenet_init_dim(ring, bcmgenet_dim_work);
/* Initialize Rx NAPI */
netif_napi_add(priv->dev, &ring->napi, bcmgenet_rx_poll,
@@ -2186,7 +2213,6 @@ static int bcmgenet_init_rx_ring(struct bcmgenet_priv
*priv,
bcmgenet_rdma_ring_writel(priv, index, 0, RDMA_PROD_INDEX);
bcmgenet_rdma_ring_writel(priv, index, 0, RDMA_CONS_INDEX);
- bcmgenet_rdma_ring_writel(priv, index, 1, DMA_MBUF_DONE_THRESH);
bcmgenet_rdma_ring_writel(priv, index,
((size << DMA_RING_SIZE_SHIFT) |
RX_BUF_LENGTH), DMA_RING_BUF_SIZE);
@@ -3424,6 +3450,7 @@ static int bcmgenet_probe(struct platform_device *pdev)
struct net_device *dev;
const void *macaddr;
struct resource *r;
+ unsigned int i;
int err = -EIO;
const char *phy_mode_str;
@@ -3552,6 +3579,11 @@ static int bcmgenet_probe(struct platform_device *pdev)
netif_set_real_num_tx_queues(priv->dev, priv->hw_params->tx_queues + 1);
netif_set_real_num_rx_queues(priv->dev, priv->hw_params->rx_queues + 1);
+ /* Set default coalescing parameters */
+ for (i = 0; i < priv->hw_params->rx_queues; i++)
+ priv->rx_rings[i].rx_max_coalesced_frames = 1;
+ priv->rx_rings[DESC_INDEX].rx_max_coalesced_frames = 1;
+
/* libphy will determine the link state */
netif_carrier_off(dev);
diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.h b/drivers/net/ethernet/broadcom/genet/bcmgenet.h
index 22c41e0430fb..b773bc07edf7 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.h
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.h
@@ -578,8 +578,6 @@ struct bcmgenet_net_dim {
u16 event_ctr;
unsigned long packets;
unsigned long bytes;
- u32 coal_usecs;
- u32 coal_pkts;
struct net_dim dim;
};
@@ -598,6 +596,8 @@ struct bcmgenet_rx_ring {
unsigned int end_ptr; /* Rx ring end CB ptr */
unsigned int old_discards;
struct bcmgenet_net_dim dim;
+ u32 rx_max_coalesced_frames;
+ u32 rx_coalesce_usecs;
void (*int_enable)(struct bcmgenet_rx_ring *);
void (*int_disable)(struct bcmgenet_rx_ring *);
struct bcmgenet_priv *priv;
