From: Sergei Shtylyov <sergei.shtyl...@cogentembedded.com>
Date: Wed, 23 Mar 2016 00:44:40 +0300
> The driver of course "knows" that the chip's reset signal is active low,
> so it drives the GPIO to 0 to reset the PHY and to 1 otherwise; however
> all this will only work iff the GPIO is specified as active-high in the
> device tree! I think both the driver and the device trees (if there are
> any -- I was unable to find them) need to be fixed in this case...
>
> Fixes: 13a56b449325 ("net: phy: at803x: Add support for hardware reset")
> Signed-off-by: Sergei Shtylyov <sergei.shtyl...@cogentembedded.com>
Applied.
